Forum: Engines
03-01-2023, 02:42 PM
|
Replies: 7
Views: 1,011
Oil
Shrew,
Have used Quicksilver 25w40.
|
Forum: Engines
02-27-2023, 07:33 PM
|
Replies: 7
Views: 1,011
|
Forum: Projects and Customisations
10-06-2022, 02:15 PM
|
Replies: 3
Views: 974
|
Forum: Electronics
08-12-2022, 10:54 AM
|
Replies: 2
Views: 699
I need another transducer - suggestions please?
My 2000 2800scr lost its transducer - broke-off because something impacted it. The wire is just dangling there. It was hooked to the factory gauge on the helm and worked fine. My understanding is...
|
Forum: Maxum Owners General Discussions
07-14-2022, 08:23 PM
|
Replies: 4
Views: 624
Impressive response (graph and all) - thank you...
Impressive response (graph and all) - thank you kindly! Here in Southern Ontario, I just payed $2.60 per litre of gas. My tank holds 380 litres (about 100 US gallons). That’s just short of $1000 for...
|
Forum: Maxum Owners General Discussions
07-14-2022, 10:37 AM
|
Replies: 4
Views: 624
Thanks yahoo82,
It seems that the 454 (7.4mpi)...
Thanks yahoo82,
It seems that the 454 (7.4mpi) is plenty big enough of an engine. It’s a stock bravo 3 prop and like I said, it comes up on plane without much effort. I wonder though if maintaining...
|
Forum: Maxum Owners General Discussions
07-12-2022, 07:48 PM
|
Replies: 4
Views: 624
Planing my 2000 2800scr
Got a question for someone out there:
On a full tank of gas and load for bear, my single engine 28’ 7.4 mpi comes up on plane no problem. Normally, I keep the tabs all the way down along with the...
|
Forum: Engines
05-04-2022, 08:13 PM
|
Replies: 9
Views: 1,835
No IAC filter for this model (2000 7.4 mpi)
Thanks for the suggestion but put a new IAC sensor - and it appears that it needed one (old one was stuck open).
Taking a closer look at the ignition wires, the ohms of resistance are a little high...
|
Forum: Engines
05-01-2022, 11:05 PM
|
Replies: 9
Views: 1,835
The manual is rather vague
I’m now down to the MAP sensor and or TPS.
It’s almost worth investing in electronic diagnostic tools - that my marina mechanic does not have either.
GeorgeK
|
Forum: Engines
05-01-2022, 06:36 PM
|
Replies: 9
Views: 1,835
Replaced the IAC - that definitely needed...
Replaced the IAC - that definitely needed replacing - the old one seemed stuck in the outward position. When it started, it raved higher - the way its suppose to.
However,
This did not solve the...
|
Forum: Engines
04-28-2022, 07:17 PM
|
Replies: 9
Views: 1,835
Thanks
I’ll get back to let you know if there were improvements with the new IAC
Thanks
GeorgeK
|
Forum: Engines
04-28-2022, 06:27 PM
|
Replies: 9
Views: 1,835
Hard starting 7.4 mpi - any suggestions please?
Hello,
It’s in a 2000 2800 Maxum Bravo 3 with a single 7.4 (454) mpi
De-winterized start was difficult. Seemed to run okay in the fall - but had to crank more than I thought was necessary.
After a...
|
Forum: Electronics
03-17-2022, 10:15 PM
|
Replies: 1
Views: 637
Will VesselView mobile work for a 2000 2800scr
I have a 2000 2800scr with a single 7.4 MPI and have been hearing great things about VesselView Mobile. I’d like to be able to use it on my boat but the compatibility stats published by Mercruiser do...
|
Forum: Maxum Owners General Discussions
02-27-2022, 01:16 PM
|
Replies: 3
Views: 529
|
Forum: Maxum Owners General Discussions
02-22-2022, 07:09 PM
|
Replies: 3
Views: 529
|
Forum: Maxum Owners General Discussions
12-31-2021, 05:50 PM
|
Replies: 2
Views: 719
Thanks again Shrew
Good winter/spring project (cable batteries from port to starboard). The list has been bugging me since purchasing the boat in 2018. It was amplified when I added the extra house battery - those 27’s...
|
Forum: Maxum Owners General Discussions
12-28-2021, 09:55 PM
|
Replies: 2
Views: 719
2800scr listing to port (3 batteries)
Hello fellow Maxum owners - any suggestions please:
I've got three 27 series batteries on the port side (recently added an extra house)
With one big battery for the engine plus 2 for the house. The...
|
Forum: Sport Cruisers
02-09-2021, 11:53 AM
|
Replies: 27
Views: 2,565
20 gallons per hour
The 2800scr uses about 20 gals per hour closer to 4000 rpm. Maybe 18 at 3700 - 3800rpm. Calculating mileage is an art in itself. The gas gauge on the boat, I believe, is meant to be read while under...
|
Forum: Sport Cruisers
02-06-2021, 08:52 PM
|
Replies: 27
Views: 2,565
I’m a very late with this post so I apologize....
I’m a very late with this post so I apologize. You’ve probably moved on etc. I have a 2000 2800scr with a single 7.4 mercruiser. It comes up on plane without any issues. The 454 is a brute of an...
|
Forum: Maxum Owners General Discussions
07-11-2020, 11:46 AM
|
Replies: 3
Views: 1,892
Cruisair a/c buzzing loudly in 2800scr
So there I was, relaxing in the cabin to escape the oppressive outside heat when I hear the loud vibration buzzing coming from the air conditioning unit. I figured it was the aluminum housing with a...
|
Forum: Maxum Owners General Discussions
06-27-2020, 11:47 AM
|
Replies: 5
Views: 656
Sound advise
I do use the 1/3 rule. My chart plotter also calculates fuel burned - so between manual calculations, the plotter and gas gauge, I have a pretty good idea.
Unfortunately, the 2800scr has only a 100...
|
Forum: Maxum Owners General Discussions
06-26-2020, 07:40 PM
|
Replies: 5
Views: 656
Thanks shrew,
I think that the engineers...
Thanks shrew,
I think that the engineers intended the gas gauge to be read while underway - for practical reasons. I found that at my slip, the gauge read 1/4 when there is actually about 1/2 tank...
|
Forum: Maxum Owners General Discussions
06-23-2020, 04:27 PM
|
Replies: 5
Views: 656
2800scr gas gauge?
Hello,
Got a question to you learned Maxum veterans. On plane my gas gas seems to read more accurately than sitting at the slip (which happens to read lower fuel).
Did the Maxum engineers, decide...
|
Forum: Maxum Owners General Discussions
03-06-2020, 11:30 AM
|
Replies: 7
Views: 743
Thanks Shrew.
I’ve been standing on ice...
Thanks Shrew.
I’ve been standing on ice prepping the lifted boat for launch in 4 weeks (heading to Canada’s most beautiful province of Florida in the mean time). I noticed a little threaded hole in...
|
Forum: Maxum Owners General Discussions
03-04-2020, 02:27 PM
|
Replies: 7
Views: 743
|