Maxum Boat Owners Club - Forum

		Maxum Boat Owners Club - Forum > Search Forums
Search Results

Click Here to Login

Showing results 1 to 19 of 19
Search took 0.01 seconds. Search: Posts Made By: broncostu

Forum: Maxum Owners General Discussions

10-31-2019, 03:22 AM

Replies: 9

leak

Views: 966

Posted By broncostu

its definitely not the swivel shaft. the leak is...

its definitely not the swivel shaft. the leak is coming thru the hull.

Forum: Maxum Owners General Discussions

10-28-2019, 11:03 PM

Replies: 9

leak

Views: 966

Posted By broncostu

i installed all new bellows earlier this year. if...

i installed all new bellows earlier this year. if the hull is not damaged (outside) would you change the transom seal? what else can it be?

Forum: Maxum Owners General Discussions

10-26-2019, 02:51 PM

Replies: 9

leak

Views: 966

Posted By broncostu

i can see where its coming in, it's a slight leak...

i can see where its coming in, it's a slight leak below the stringer where the engine mounts are located (Starboard). I'm afraid its the transom seal but just wanted to be as sure as possible.

Forum: Maxum Owners General Discussions

10-25-2019, 05:57 PM

Replies: 9

leak

Views: 966

Posted By broncostu

leak

hello all, i have 1995 1900 SR2 that has a small leak coming in the engine compartment right below the engine mount. any ideas how to id the source?
also, how do i attach an image?

Forum: Maxum Owners General Discussions

05-14-2019, 04:08 PM

Replies: 10

Water Leak

Views: 2,256

Posted By broncostu

thanks for all the help, i will clamp the shift...

thanks for all the help, i will clamp the shift boot and see how it goes.

Forum: Maxum Maintenance

05-14-2019, 01:41 PM

Replies: 20

Transom Leaking

Views: 6,138

Posted By broncostu

what is the modification for?

what is the modification for?

Forum: Maxum Owners General Discussions

05-14-2019, 11:38 AM

Replies: 10

Water Leak

Views: 2,256

Posted By broncostu

were you able to see water coming in from that...

were you able to see water coming in from that leak. there is very little water in the bilge, that's what worries me. much more water is coming out of the drain (after pulling out of the water) than...

Forum: Maxum Owners General Discussions

05-14-2019, 11:35 AM

Replies: 10

Water Leak

Views: 2,256

Posted By broncostu

mike, i did install the metal clamp on the small...

mike, i did install the metal clamp on the small end of shift cable. i slipped it over the small end and left it loose. i assume this is right. Should i squeeze the clamp on the small end of the...

Forum: Maxum Owners General Discussions

05-14-2019, 01:52 AM

Replies: 10

Water Leak

Views: 2,256

Posted By broncostu

mike - im positive its not an engine leak. if the...

mike - im positive its not an engine leak. if the transom seal is leaking will it be visible? also, where is the swivel shaft seal located? it seams like its leaking into the hull, because there is...

Forum: Maxum Owners General Discussions

05-13-2019, 05:02 PM

Replies: 10

Water Leak

Views: 2,256

Posted By broncostu

Water Leak

hello, i have a 1996 1900 SR2 trying to find a leak. i am a new boat owner so looking for input. i purchased it a few months ago and changed the bellows which i thought fixed the leak. there is very...

Forum: Sport Boats

04-18-2019, 12:55 AM

Replies: 2

hydrofoils

Views: 1,157

Posted By broncostu

hydrofoils

hello all -

i just purchased a 1998 1900 SR2 and it cam with a hydrofoil attached. looking for opinions, should i leave it or take it off. i am new to boating so thanks for your feedback.

Forum: Maxum Maintenance

04-17-2019, 12:55 AM

Replies: 14

trim innoperable

Views: 1,986

Posted By broncostu

Doug, it must have been as you described "out of...

Doug, it must have been as you described "out of alignment" they are working properly now. i have the same issue with my shift/throttle toggle switch. it only trims down. i have to use the trailer...

Forum: Maxum Maintenance

04-13-2019, 12:26 PM

Replies: 14

trim innoperable

Views: 1,986

Posted By broncostu

trim innoperable

hello all, i changed the bellows in my 98 SR2. i got it all back together and the trim was working erratically then quit. any thoughts?

Forum: Welcome Mat | New Member Introductions

04-05-2019, 11:24 PM

Replies: 15

new boat owner

Views: 2,301

Posted By broncostu

that was my next question...should i try changing...

that was my next question...should i try changing all the bellows myself. the shift bellows is torn and the drive shaft bellows is showing signs of age. can anyone lend me a how to link for the...

Forum: Welcome Mat | New Member Introductions

04-05-2019, 11:22 PM

Replies: 15

new boat owner

Views: 2,301

Posted By broncostu

changed oil and filter, new fuel/water filter,...

changed oil and filter, new fuel/water filter, gear oil.

Forum: Welcome Mat | New Member Introductions

03-31-2019, 05:41 PM

Replies: 15

new boat owner

Views: 2,301

Posted By broncostu

Thanks again for everyone's input. took it out...

Thanks again for everyone's input. took it out for the first time yesterday. All went well, fired right up and planed out nice, ran about 47 mph. i did notice water coming in from the rear and i know...

Forum: Welcome Mat | New Member Introductions

03-27-2019, 11:54 PM

Replies: 15

new boat owner

Views: 2,301

Posted By broncostu

thanks all, i changed the impeller, started and...

thanks all, i changed the impeller, started and ran for a while and noticed water coming from the weep hole on the water pump. i will check with oreilleys.

Forum: Welcome Mat | New Member Introductions

03-27-2019, 08:51 PM

Replies: 15

new boat owner

Views: 2,301

Posted By broncostu

engine parts

i need an alternator and water pump for my 4.3 Merc. does autozone carry them?

Forum: Welcome Mat | New Member Introductions

03-26-2019, 01:56 AM

Replies: 15

new boat owner

Views: 2,301

Posted By broncostu

new boat owner

hello all! just purchased a 1998 1900 SR2 (actually my Sons purchased). The boat has low hours but we have no history information and I/we have never owned a boat. We were not able to test the boat...

Showing results 1 to 19 of 19

All times are GMT. The time now is 08:57 AM.