Go Back   Maxum Boat Owners Club - Forum > Search Forums
Click Here to Login
Register FAQ Community Calendar Today's Posts Log in

Showing results 1 to 25 of 26
Search took 0.00 seconds.
Search: Posts Made By: Jbleaux
Forum: Engines 08-17-2018, 04:54 PM
Replies: 12
Views: 2,375
Posted By Jbleaux
I believe the trim lines are melted because there...

I believe the trim lines are melted because there is fluid inside the boat underneath the containment area under the motor.
Forum: Engines 08-17-2018, 12:12 PM
Replies: 12
Views: 2,375
Posted By Jbleaux
It’s a 1989 maxim with a 3.0 muricruiser with a...

It’s a 1989 maxim with a 3.0 muricruiser with a alpha 1 gen 1 outdrive. Sorry. I have been really busy. I am going to start taking it apart today after work. I am going to the parts store and...
Forum: Engines 08-15-2018, 12:20 AM
Replies: 12
Views: 2,375
Posted By Jbleaux
That sounds like a good starting list. I will...

That sounds like a good starting list. I will start taking it apart tomorrow hopefully. All I know is it stopped getting water to the motor at this point. It literally ran for 3 minutes. But yes. My...
Forum: Engines 08-14-2018, 08:38 PM
Replies: 12
Views: 2,375
Posted By Jbleaux
Big problems

Normally I watch the gauges but did not yesterday. I ended up hitting 240 for a temp. My rubber exhaust connecters burnt, my trim motor does not work now and was leaking water/oil behind the motor, ...
Forum: Engines 07-17-2018, 03:25 PM
Replies: 5
Views: 1,122
Posted By Jbleaux
Thanks Mike.

Thanks Mike.
Forum: Engines 07-17-2018, 10:26 AM
Replies: 5
Views: 1,122
Posted By Jbleaux
It’s an 1989. Sorry I forgot that part. As for a...

It’s an 1989. Sorry I forgot that part. As for a weld on skeg that is something I can do. Are props interchangeable as long as they are the same size blade? I have never taken one apart and replaced...
Forum: Engines 07-17-2018, 12:48 AM
Replies: 5
Views: 1,122
Posted By Jbleaux
1 in a million hit on debris.

So just as the heading states. I hit something in the water. There is a 1/4 of the skeg left and a chip out of the propeller. I had no clue there was ant damage done to the lower end till I took it...
Forum: Engines 05-25-2018, 12:13 AM
Replies: 29
Views: 4,206
Posted By Jbleaux
I am giving up for a couple days. I need to re...

I am giving up for a couple days. I need to re energize. I replaced the coil, distributer cap, points, plug wires, and solenoid. All I can say is that I have around 1 volt going into the cap and...
Forum: Engines 05-21-2018, 08:37 AM
Replies: 29
Views: 4,206
Posted By Jbleaux
I will check it out. Thanks.

I will check it out. Thanks.
Forum: Engines 05-21-2018, 01:20 AM
Replies: 29
Views: 4,206
Posted By Jbleaux
I moved the fuse and wire to an unused spot on...

I moved the fuse and wire to an unused spot on the panel. I am in the procces of looking for a new fuse panel. Shopped around locally with no luck, but I have some other places I can look online.
Forum: Maxum Owners General Discussions 05-21-2018, 01:16 AM
Replies: 6
Views: 1,138
Posted By Jbleaux
No. It really does not matter. But when you hear...

No. It really does not matter. But when you hear and see different things it makes you wonder what it really is. Like I mensioned last week it’s my first boat and this is a learning experiance. The...
Forum: Maxum Owners General Discussions 05-20-2018, 11:35 PM
Replies: 6
Views: 1,138
Posted By Jbleaux
Boat size?

I measured the boat from the tip of the front to the very back and it said 22.5 feet, it’s registered as a 19 foot, and the previous owner said it was a 21 foot boat. I am so confused. Lol. How can I...
Forum: Projects and Customisations 05-20-2018, 11:31 PM
Replies: 6
Views: 2,071
Posted By Jbleaux
I saw them on eBay not to long ago. Not sure what...

I saw them on eBay not to long ago. Not sure what I was looking up.
Forum: Engines 05-20-2018, 11:28 PM
Replies: 29
Views: 4,206
Posted By Jbleaux
So it’s turning over now. Come to find out the...

So it’s turning over now. Come to find out the tab on the fuse panel where the wire plugs in does not have power to it. What a head ach. Now the distributor cap is junk so I ordered a tune up kit....
Forum: Engines 05-17-2018, 12:17 PM
Replies: 29
Views: 4,206
Posted By Jbleaux
Lights, bulge pump, tilt/trim, etc.

Lights, bulge pump, tilt/trim, etc.
Forum: Engines 05-16-2018, 05:26 PM
Replies: 29
Views: 4,206
Posted By Jbleaux
Plattsburgh ny. Lake Champlain is in my back...

Plattsburgh ny. Lake Champlain is in my back yard. Thanks for the help.
Forum: Engines 05-16-2018, 04:06 PM
Replies: 29
Views: 4,206
Posted By Jbleaux
This may sound like a dumb question, but where is...

This may sound like a dumb question, but where is the fuse panel. And no power on the key switch at all. It would make sense if there is a fuse panel. It must be hidden well. Lol.
Forum: Engines 05-16-2018, 12:02 PM
Replies: 29
Views: 4,206
Posted By Jbleaux
I didn’t see any fuses at all. The red breaker is...

I didn’t see any fuses at all. The red breaker is fine. I need to mess with the shifter and the wires going to and from it. That’s my next guess.
Forum: Engines 05-16-2018, 12:32 AM
Replies: 29
Views: 4,206
Posted By Jbleaux
So I tied them to together earlier today and...

So I tied them to together earlier today and still have no power going to the key switch. I am getting really frustrated with this boat. I know it runs and I know there is power going to everything...
Forum: Engines 05-15-2018, 09:36 PM
Replies: 29
Views: 4,206
Posted By Jbleaux
This has been a nightmare. The list price when...

This has been a nightmare. The list price when you could get them new was 32.00. Some people on eBay want 80.00 for a used one. I found a valve cover with the shift assembly and switch on it still...
Forum: Engines 05-15-2018, 09:46 AM
Replies: 29
Views: 4,206
Posted By Jbleaux
Ok, thanks. I thought about trying it but was not...

Ok, thanks. I thought about trying it but was not sure.
Forum: Engines 05-15-2018, 01:18 AM
Replies: 29
Views: 4,206
Posted By Jbleaux
Ok. Thanks.

Ok. Thanks.
Forum: Engines 05-15-2018, 12:00 AM
Replies: 29
Views: 4,206
Posted By Jbleaux
It turned out to be the neutral safety switch....

It turned out to be the neutral safety switch. Unfortunately I have to search for it because the supplier at our local shop here can not get it anymore. I wanted to be on the water today. ��. Thanks...
Forum: Engines 05-14-2018, 12:26 PM
Replies: 29
Views: 4,206
Posted By Jbleaux
Great. Thank you. You have me thinking it’s the...

Great. Thank you. You have me thinking it’s the neutral safety switch. I just need to look threw the diagram and figure out the wiring. Thanks again, I know my way around a car motor but these are a...
Forum: Engines 05-14-2018, 07:37 AM
Replies: 29
Views: 4,206
Posted By Jbleaux
Thanks for the info. I can’t find a fuse...

Thanks for the info. I can’t find a fuse anywhere. I did have the lever in Nuteral but still no power. I am having a hard time tracing the wires and where they all go to. I looked for a wiring...
Showing results 1 to 25 of 26

 
Forum Jump

All times are GMT. The time now is 04:38 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.