Showing results 1 to 25 of 33
Search took 0.00 seconds.
Search: Posts Made By: arichard
Forum: Maxum Owners General Discussions 03-13-2019, 04:53 PM
Replies: 21
Views: 3,730
Posted By arichard
My 2400 is on the deck in its original location,...

My 2400 is on the deck in its original location, nothing in the anchor locker area. Must be a Canadian thing. :P
Forum: Sport Cruisers 11-20-2018, 07:19 PM
Replies: 8
Views: 3,221
Posted By arichard
I have seen alternators and rectifiers pump out...

I have seen alternators and rectifiers pump out too many amps that can cause this issue. You may want to check this while running.
Forum: Sport Cruisers 07-03-2018, 04:17 PM
Replies: 33
Views: 9,655
Posted By arichard
So this means that you do use the inverter. To...

So this means that you do use the inverter. To be safe, verify that it can be installed in this location. A simple spark in that area wouldn't be a great idea which is why the majority of them need...
Forum: Maxum Owners General Discussions 06-22-2018, 04:40 PM
Replies: 14
Views: 7,356
Posted By arichard
I use an impact screw driver with a rubber mallet...

I use an impact screw driver with a rubber mallet for this type of screw. Always comes off and far less chance of stripping it.
Forum: Engines 06-22-2018, 03:06 PM
Replies: 14
Views: 1,764
Posted By arichard
I think he is talking about trimming up the lower...

I think he is talking about trimming up the lower unit.. :) Mine is direct to the battery as well.
Forum: Maxum Owners General Discussions 05-25-2018, 02:46 PM
Replies: 2
Views: 1,160
Posted By arichard
I installed this on my boat 2 years ago and it...

I installed this on my boat 2 years ago and it was simple to install. Removing it I assume would be like removing any other product being held on with 3M. Keep pulling and peel and then clean the...
Forum: Electronics 04-26-2018, 02:05 PM
Replies: 10
Views: 3,048
Posted By arichard
Normally if the green light is on and nothing...

Normally if the green light is on and nothing from the compressor, could still be the LED in the switch as that is also your temp control. If its bad, it will show the LED on but the compressor...
Forum: Electronics 04-25-2018, 06:28 PM
Replies: 10
Views: 3,048
Posted By arichard
I had a similar issue with the 110 working but...

I had a similar issue with the 110 working but 12v not. It may be the same issue. Link to my fix.
...
Forum: Maxum Maintenance 03-08-2018, 03:46 PM
Replies: 13
Views: 4,232
Posted By arichard
I can confirm this as well. I have seen what...

I can confirm this as well. I have seen what happens after a few months and it aint pretty! I few RVs where I camp in the summer did this last year and half way through they were yellowing and...
Forum: The Dock Walk 01-31-2018, 03:08 PM
Replies: 9
Views: 2,770
Posted By arichard
Congrats!

Congrats!
Forum: Welcome Mat | New Member Introductions 01-15-2018, 01:51 PM
Replies: 4
Views: 1,315
Posted By arichard
Welcome to the forum!! I have a 94' 2400 SCR...

Welcome to the forum!! I have a 94' 2400 SCR that's asleep atm. ;)
Forum: Electronics 11-30-2017, 07:46 PM
Replies: 11
Views: 2,773
Posted By arichard
You need to go onto the rear bed on the port side...

You need to go onto the rear bed on the port side of the boat and look up. Remove the screws and the panel will come down. wires can be run in that area from the engine bay wall to the closet. ...
Forum: Maxum Owners General Discussions 11-14-2017, 03:34 PM
Replies: 5
Views: 2,716
Posted By arichard
Have the same boat! Had the same problem. Only...

Have the same boat! Had the same problem. Only way out is to remove the door and then the compressor and everything off the back, including the cooling fins and inside the fridge out the back. ...
Forum: Welcome Mat | New Member Introductions 10-13-2017, 03:47 PM
Replies: 4
Views: 1,236
Posted By arichard
Welcome aboard!

Welcome aboard!
Forum: Maxum Owners General Discussions 06-07-2017, 05:03 PM
Replies: 8
Views: 1,347
Posted By arichard
Here are the two points of entry to the motor...

Here are the two points of entry to the motor that I believe are used for the hot water tank. Took the pictures yesterday. Does this look familiar to anyone?

...
Forum: Maxum Owners General Discussions 06-06-2017, 02:29 PM
Replies: 8
Views: 1,347
Posted By arichard
Hi, It isn't. It's a small one I take out if...

Hi,

It isn't. It's a small one I take out if needed and I put it on the rear swim platform. Honestly very rare I take it out to use. Running the boat and moving around from spot to spot gives my...
Forum: Maxum Owners General Discussions 06-06-2017, 11:56 AM
Replies: 8
Views: 1,347
Posted By arichard
That would be great if you found a pic! Thxs

That would be great if you found a pic! Thxs
Forum: Maxum Owners General Discussions 06-06-2017, 11:55 AM
Replies: 8
Views: 1,347
Posted By arichard
The water heater is already hooked up to breaker...

The water heater is already hooked up to breaker panel for power. Works great when docked but when I am out for a few days on the water it would be nice to be able to run it off the engine. I have a...
Forum: Maxum Owners General Discussions 06-05-2017, 07:27 PM
Replies: 8
Views: 1,347
Posted By arichard
Help with adding water connections from Engine to hot water tank.

Hi everyone.

I would like to add the hose connections from my motor (94 5.7l) to the hot water tank. Presently it never had this plumbed in. The hot water tank has the connections for it, but...
Forum: Electronics 05-30-2017, 02:07 PM
Replies: 22
Views: 4,362
Posted By arichard
I have two guesses... The previous owner had an...

I have two guesses... The previous owner had an issue where the bilge pump killed the battery, so they essentially ran two power wires back to the batteries hoping if it happened again they would...
Forum: Maxum Owners General Discussions 05-10-2017, 04:20 PM
Replies: 6
Views: 4,099
Posted By arichard
I posted on a previous thread a fix for the older...

I posted on a previous thread a fix for the older Norcold fridges for this exact problem. What model fridge is it? The LED light is the cause of the issue normally as long as you have 12V going to...
Forum: Maxum Owners General Discussions 04-24-2017, 03:36 PM
Replies: 14
Views: 6,056
Posted By arichard
My fuel pump was electrical as well, but was only...

My fuel pump was electrical as well, but was only engaged when the engine was running. I believe that is a safety requirement so if the motor catches fire and stops running, no more fuel keeps...
Forum: Maxum Owners General Discussions 04-24-2017, 02:27 PM
Replies: 14
Views: 6,056
Posted By arichard
Totally agree about cranking engine over to...

Totally agree about cranking engine over to engage the fuel pump to fill the carbs!! On my last boat I had the fuel pump wired into the ignition so when I put the key it, I turn it once and I would...
Forum: Maxum Owners General Discussions 04-21-2017, 06:52 PM
Replies: 14
Views: 6,056
Posted By arichard
Pushing the throttle forward all the way is what...

Pushing the throttle forward all the way is what engages the primer in the carb. You could always try 5 times, but I would suggest replacing the rubber valve in the carb that is your primer. Also,...
Forum: Maxum Owners General Discussions 04-21-2017, 06:46 PM
Replies: 14
Views: 6,056
Posted By arichard
What is your starting procedure before cranking...

What is your starting procedure before cranking it over? Are you priming the carbs correctly with the throttle before cranking?
Showing results 1 to 25 of 33

 
Forum Jump

All times are GMT. The time now is 09:57 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.