Showing results 1 to 25 of 31
Search took 0.00 seconds.
Search: Posts Made By: gentlemanglobetrotter
Forum: Engines 07-12-2010, 01:12 PM
Replies: 23
Views: 7,110
Fixed - Fixed - Fixed

Finally got this problem licked, cheers for all the inputs and suggestions they all helped and I am now an expert on the Merc 350 mag mpi lol

Traced the fault down to a wonky ignition coil plug,...
Forum: Engines 07-08-2010, 08:35 PM
Replies: 23
Views: 7,110
Changed crankshaft sensor, fuel & power relay all...

Changed crankshaft sensor, fuel & power relay all to no avail

Printed wiring diagrams and got stuck in with new multimeter, i have 12v at both the ignition coil and module so the ecm is not...
Forum: Engines 07-08-2010, 01:28 PM
Replies: 23
Views: 7,110
Changed ECM along with start neutral safety...

Changed ECM along with start neutral safety switch & HT lead from coil, problem still exists so hoping to get crankshaft sensor and power relay to change over

I think after that its then down to a...
Forum: Engines 07-05-2010, 08:13 PM
Replies: 23
Views: 7,110
Interesting Captainron as that is next on my...

Interesting Captainron as that is next on my list, i am lucky that my Merc dealer has a spare Mag 350 with a cracked block (insurance replaced) so i now have access to all the bits i need to try, i...
Forum: Engines 06-28-2010, 11:07 PM
Replies: 23
Views: 7,110
Hi Dan Yes i did replace ignition coil &...

Hi Dan

Yes i did replace ignition coil & module

Any idea where to get a copy of the wiring schematic from as i want to check every connection here

Will go down at night and have a look
...
Forum: Engines 06-27-2010, 01:35 PM
Replies: 23
Views: 7,110
Still issues

Hi all, well nearly a year down the line and still have this intermittent problem just back of the water today where I went out and ran at 1500rpm for approx 1 hour then as I approached a jetty for...
Forum: Engines 06-24-2010, 10:14 AM
Replies: 4
Views: 6,527
https://www.maxumownersclub.com/attachments/photobu...

https://www.maxumownersclub.com/attachments/photobucket/img_10285_0_d0316fcb00f1c7a06a5fdae526f8c680.jpg[/IMG]
Forum: Engines 06-24-2010, 10:00 AM
Replies: 4
Views: 6,527
Hi SP Cheers for response although not sure we...

Hi SP Cheers for response although not sure we are talking about same part here

This is a little piece approx 3/4" square bit of sponge, i'd call it a filter American websites sites call it a...
Forum: Engines 06-23-2010, 03:28 PM
Replies: 4
Views: 6,527
Intake Air Control Muffler sucked into Mag 350 MPI

Was out last night and noticed a rather loud sucking noise from engine, headed out of marina and tried to get onto plane struggled to get above 3500rpm

On removing the flame arrestor and cover i...
Forum: Sport Cruisers 05-18-2010, 09:38 PM
Replies: 2
Views: 2,522
Not quite right but thanks, have added pic...

Not quite right but thanks, have added pic showing what decal looks like on rear of swim step

...
Forum: Sport Cruisers 05-18-2010, 09:27 PM
Replies: 5
Views: 1,830
Talking Lazy mornings

Hi, i have a 2700 SCR and had the same issue, i have what i guess is mozzy nets/covers for all the windows & skyelight so i just used some good stiff cardboard and cut a perfect circle matching the...
Forum: Sport Cruisers 05-12-2010, 11:25 PM
Replies: 2
Views: 2,522
2700 SCR Decals/graphics

Hi, i'm looking for help in finding decals/graphics for my 2700SCR in particular i'm looking for the 2700 SCR decal on the stern/swim platform, ideally in the UK but US ok, original past its sell by...
Forum: Engines 08-17-2009, 08:59 PM
Replies: 23
Views: 7,110
Re: Intermitant Fault with mag 350 MPI

Hi,

I had a fuel pressure gauge on to check pressure all seemed ok, and def no fuel leaks in or arround the engine, but i'll keep it in mind if the gremlins reappear, cheers
Forum: Engines 08-17-2009, 08:57 PM
Replies: 23
Views: 7,110
Re: Intermitant Fault with mag 350 MPI

Still convinced it was dirt in the fuel lines, think maybe its finally been fired through, in reality the only two things that were done were inline fuel filter & water seperator/fuel filter were...
Forum: Maxum Owners General Discussions 08-12-2009, 02:06 PM
Replies: 2
Views: 1,622
Re: Canvas frame bow jaw slide measurements

I have done this but according to the supplement you can get the factory settings from your dealer? (I bought second hand so don't have a dealer)Obviously they must exist i would prefer to get them...
Forum: Maxum Owners General Discussions 08-12-2009, 02:01 PM
Replies: 9
Views: 7,505
Re: TRIM TABS CORRECT USE

Could you explain what you mean by no tab effect? So far i have put drive down, tabs down then open throttle to about 4000-4200 where i come up on to the plane, i then back off throttle to about...
Forum: Maxum Owners General Discussions 08-12-2009, 01:54 PM
Replies: 9
Views: 7,505
Re: TRIM TABS CORRECT USE

Yes i like the idea of 1 less thing to have to think about but thanks for the reply i need to try now without to see what happens, all trial and error i guess
Forum: Maxum Owners General Discussions 08-11-2009, 11:06 PM
Replies: 2
Views: 1,622
Canvas frame bow jaw slide measurements

Can anyone tell me where i can get these measurements, the previous owner of my 2700SCR with radar wing has clearly had these adjusted all over the place making the canopy tight in areas to secure....
Forum: Maxum Owners General Discussions 08-11-2009, 10:43 PM
Replies: 9
Views: 7,505
Re: TRIM TABS CORRECT USE

Cheers for that Seapuppy :D
Forum: Maxum Owners General Discussions 08-11-2009, 10:07 PM
Replies: 9
Views: 7,505
TRIM TABS CORRECT USE

Right don't all laugh at once but as this is my first boat i need to ask the question or questions, what is the correct use for trim tabs on my 2700SCR

If i read my owners supplement it would...
Forum: Engines 08-11-2009, 09:30 PM
Replies: 23
Views: 7,110
Re: Intermitant Fault with mag 350 MPI

Update - Had the boat out all weekend on the plane giving it plenty, would appear the gremlins have disappeared for now anyway :lol:
Forum: Engines 07-28-2009, 01:16 PM
Replies: 23
Views: 7,110
Re: Intermitant Fault with mag 350 MPI

Hi SP, yes going to have to go over them all with a fine tooth comb, i had a guy on the boat doing a tonage meaurement to do with registering with the shipping act etc, anyway i never met him, his...
Forum: Engines 07-27-2009, 08:42 PM
Replies: 23
Views: 7,110
Re: Intermitant Fault with mag 350 MPI

Hi i was thinking there was a clue in the subject header "Re: Intermitant Fault with mag 350 MPI" lol :D
Forum: Engines 07-26-2009, 10:53 PM
Replies: 23
Views: 7,110
Intermitant Fault with mag 350 MPI

Hi & Help, bought 1st boat couple of months ago, Maxum 2700SCR (2003) only 60 hrs on engine, been fun up to a few weeks ago, now 74 hrs on engine

Problems-
1) Notice leaving marina at idle engine...
Forum: Engines 04-09-2009, 12:22 PM
Replies: 2
Views: 1,613
Thanks, have spoken to a couple of mates on this...

Thanks, have spoken to a couple of mates on this as well, as you say you can buy a lot of petrol for £10k, think i'll stick with petrol, cheers
Showing results 1 to 25 of 31

 
Forum Jump

All times are GMT. The time now is 07:25 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.