Forum: Maxum Maintenance
05-29-2009, 12:44 AM
|
Replies: 2
Views: 2,946
Re: Seat Removal For Recovering
Both my drivers seat and passenger seat fold flat. I was hoping that I could haul both seats back and they would come out of the grooves and not have to unscrew anything. The plywood is starting to...
|
Forum: Maxum Maintenance
05-18-2009, 09:52 PM
|
Replies: 2
Views: 2,946
Seat Removal For Recovering
I have a 1991 Maxum 23 scr and was looking at removing the main driver's seat for recovering. It is the long seat with front and back seating and can fold down flat. Is there an easy way of...
|
Forum: Electronics
05-05-2009, 11:03 AM
|
Replies: 4
Views: 2,396
Shows 12 Volts but no power
I have an anchor light where the socket shows 12 volts yet when I put the light in place it doesn't work. When I run the light off the battery directly it works fine. Both sources showing pretty...
|
Forum: Maxum Maintenance
10-24-2008, 03:11 PM
|
Replies: 7
Views: 5,791
|
Forum: Electronics
10-24-2008, 11:23 AM
|
Replies: 3
Views: 4,793
Dash Access
There must be an easier access to under the dash than just that small retangular opening under the wheel. You have to be a pretty flexible to fit inbetween the seat and wheel and still look up the...
|
Forum: Maxum Maintenance
10-24-2008, 11:17 AM
|
Replies: 7
Views: 5,791
|
Forum: Engines
10-20-2008, 10:11 AM
|
Replies: 5
Views: 4,731
|
Forum: Electronics
10-19-2008, 11:47 PM
|
Replies: 3
Views: 4,793
1991 2300 SCR Wiring Diagram
Got this boat in late September and a few electronics not working like the Radio, Nav Lights, Anchor Lights, and Horn. Macerator pump not working either but not sure where that one is located. It...
|
Forum: Engines
10-19-2008, 11:26 PM
|
Replies: 5
Views: 4,731
Thanks
Thanks for the help, I will put a gauge on each manifold to monitor the temperature. I was out today and although the STBD stayed Hotter than the Port, it levelled out and did not continue to...
|
Forum: Engines
10-19-2008, 10:41 AM
|
Replies: 5
Views: 4,731
Port Manifold/Riser running hotter than STBD side
I have a 5.7 L in a 1991 2300 SCR and recently had her at the shop where the leg was rebuilt and new port manifold installed. The mechanics say the manifold and risers were clear yet after 15 mins...
|