Showing results 1 to 25 of 26
Search took 0.00 seconds.
Search: Posts Made By: RayTrask
Forum: Maxum Owners General Discussions 08-26-2020, 05:59 PM
Replies: 3
Views: 628
Posted By RayTrask
I looked and looked, made in Italy I believe. I...

I looked and looked, made in Italy I believe. I had to find one from RONA, or maybe Home Depot that fit but the knob didnt fit over the threads so i drilled out the hole in the handle so that it fit...
Forum: Sport Yachts 07-27-2020, 06:33 PM
Replies: 3
Views: 1,123
Posted By RayTrask
the water apparently was high enough and with the...

the water apparently was high enough and with the person driving the boat got her on plane so as to get to a marina as fast as possible which pushed the water back. in looking at diagrams I see...
Forum: Engines 07-27-2020, 06:25 PM
Replies: 6
Views: 630
Posted By RayTrask
many thanks, had them do both engine impellers...

many thanks, had them do both engine impellers and back flush which was great advise, I also have been in touch with Seaboard, great people. thanks
Forum: Engines 07-06-2020, 06:11 PM
Replies: 6
Views: 630
Posted By RayTrask
the issue is my Port engine impeller blew apart,...

the issue is my Port engine impeller blew apart, concerning the temp gauge didn't reflect high temp before I shut her down. I was only able to find one piece of the impeller, I was advised that I...
Forum: Sport Yachts 07-06-2020, 05:56 PM
Replies: 3
Views: 1,123
Posted By RayTrask
listing 41 SCA

I had a flood from my starboard engine, water intake hose came off and flooded the starboard side of my boat, half way up the engine and all of the rear bedroom floor. The guys did a great job of...
Forum: Engines 07-03-2020, 08:10 PM
Replies: 6
Views: 630
Posted By RayTrask
thanks, I am running cummins 370 turbo. I was...

thanks, I am running cummins 370 turbo. I was looking at he engine diagram and saw two sensors, as my oil gauge has always been a bit flakey by jumping around once in a while and I have swapped...
Forum: Engines 07-03-2020, 03:07 PM
Replies: 6
Views: 630
Posted By RayTrask
1999 SCA 4100 enging warning alarm

my port engine warning lamp and alarm went off while on our first day out with the boat, I checked the oil pressure and temp gauge before I shut the engine off and nothing showed as out of normal...
Forum: Engines 07-02-2020, 12:13 PM
Replies: 0
Views: 523
Posted By RayTrask
1999 4100 SCA engine warning alarm

my port engine warning lamp and alarm went off while on our first day out with the boat, I checked the oil pressure and temp gauge before I shut the engine off and nothing showed as out of normal...
Forum: Sport Yachts 08-28-2019, 01:30 AM
Replies: 5
Views: 1,652
Posted By RayTrask
Thanks for all those replied. In regards to...

Thanks for all those replied.
In regards to Question #1, yes it looks like EVA product is what I need for the swim platform, thanks.
#2 Apparently in Canada they did install glow plugs in the...
Forum: Sport Yachts 07-30-2019, 06:51 PM
Replies: 5
Views: 1,652
Posted By RayTrask
1999 4100 SCA questions

1. Looking to put that teak rubber flooring down up on the bridge and down on the back sitting area. Any idea's as to what product to use or where I might find a template if I do it myself ?
2....
Forum: Maxum Owners General Discussions 09-10-2018, 10:20 PM
Replies: 2
Views: 882
Posted By RayTrask
Washdown pump

the pressure switch kit broke on my FloJet pump, MOD 4305 I believe I can just get the pressure switch kit vs buying a whole new wash down pump, anyone have suggestions as to best place to order one....
Forum: Maxum Owners General Discussions 09-10-2018, 10:16 PM
Replies: 4
Views: 993
Posted By RayTrask
yup, I had them replace it. the boats coming out...

yup, I had them replace it. the boats coming out soon so I can get the length and diameter and get a price for a new shaft then. thanks
Forum: Maxum Owners General Discussions 09-07-2018, 02:45 PM
Replies: 4
Views: 993
Posted By RayTrask
Drive shaft 4100 SCA

I have to replace my drive shaft on my 1999 4100 SCA, the boat is still in the water. Does anyone know the length of the shaft, I believe its a 2" shaft and is it hard to replace myself. Had it...
Forum: Sport Yachts 05-17-2018, 12:47 AM
Replies: 10
Views: 1,908
Posted By RayTrask
Thanks all. This is very helpful. I am looking...

Thanks all. This is very helpful. I am looking for what would be the acceptable amount the shaft can be off. I have been told 4 1000th up to 6 1000 of an inch. As well any suggestions where I might...
Forum: Sport Yachts 05-15-2018, 11:40 AM
Replies: 10
Views: 1,908
Posted By RayTrask
thanks all, strut is ok. sounds like cutlass...

thanks all, strut is ok. sounds like cutlass bearing which they did suggest I replace and I will have them check the shaft seals.
Forum: Sport Yachts 05-14-2018, 04:43 PM
Replies: 10
Views: 1,908
Posted By RayTrask
Thanks, I had a run in with a rock. When the...

Thanks, I had a run in with a rock. When the marina took the prop off they claim the shaft is 10th one thousands of an inch off so I took it off to have it verified. I am told anything over 6...
Forum: Sport Yachts 05-14-2018, 01:22 PM
Replies: 10
Views: 1,908
Posted By RayTrask
Drive shaft 4100 SCA

I have my drive shaft off on my 1999 4100 SCA, was looking for advice as to what I should consider replacing before I have it reinstalled ?
Forum: Maxum Owners General Discussions 08-21-2016, 11:05 PM
Replies: 0
Views: 1,300
Posted By RayTrask
boat listing starboard side

I have a 1999 4100 SCA, earlier in the summer I had a water hose come off my starboard engine that just about sunk the boat, the water was approx. 2.5 feet in the boat, half way up the starboard...
Forum: Maxum Owners General Discussions 08-03-2016, 10:59 PM
Replies: 2
Views: 974
Posted By RayTrask
What Size of Gene

I have a problem with starting my Westerbeke Gene, when I push up the start button I hear a tick sound but nothing happens, just dead, if I do it several times it will eventually kick in aqd Start....
Forum: Maxum Owners General Discussions 07-23-2016, 04:23 PM
Replies: 4
Views: 2,873
Posted By RayTrask
Question Inverter alarm going off while under power, starb...

Inverter alarm going off while under power, starb eng gauge reads 16 V, Port 14. alarm on inverter reading 16.2. got back to port shut her down. a week later. gene and Starb eng wont turn over, Port...
Forum: Sport Yachts 07-23-2016, 03:42 PM
Replies: 8
Views: 1,886
Posted By RayTrask
found it guys, mine is from the Starboard with no...

found it guys, mine is from the Starboard with no switch. another mystery solved. thanks all.
Forum: Maxum Owners General Discussions 07-19-2016, 11:29 AM
Replies: 4
Views: 2,873
Posted By RayTrask
Thanks Mike

appreciate your help Mike, I will do more research this weekend. Will try different scenarios, document and respond over the weekend. Appreciate your help, I'm a 1st time boat owner, the learning...
Forum: Maxum Owners General Discussions 07-19-2016, 12:13 AM
Replies: 4
Views: 2,873
Posted By RayTrask
Unhappy Over charging ?

I have a 1999 SCR 41, twin Cummins, generator and a fairly new Inverter. this happened late last year and more frequent this year. The panel that is hooked to my inverter usually shows 12.5 - 13...
Forum: Sport Yachts 07-05-2016, 11:41 AM
Replies: 8
Views: 1,886
Posted By RayTrask
Thanks Mike, however the Genny is in the middle...

Thanks Mike, however the Genny is in the middle of the boat in between the Transmissions and drive shafts.
Forum: Sport Yachts 07-04-2016, 11:44 PM
Replies: 8
Views: 1,886
Posted By RayTrask
Red face Generator fuel draws from which tank ?

I have a 1999 SCR 41, would anyone one happen to know what tank the fuel draws from, Port or Starb ?
Showing results 1 to 25 of 26

 
Forum Jump

All times are GMT. The time now is 01:04 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.