Showing results 1 to 25 of 109
Search took 0.00 seconds.
Search: Posts Made By: dsbunton646
Forum: Engines 11-16-2014, 01:31 PM
Replies: 12
Views: 8,422
Posted By dsbunton646
That filter was changed when the carb was...

That filter was changed when the carb was rebuilt.

I think it is just a bad tach gauge. I pulled the under side cover out and checked the connections, pulled and cleaned the wire connections, and...
Forum: Engines 11-16-2014, 01:26 PM
Replies: 12
Views: 8,422
Posted By dsbunton646
I removed the tank vent line and was able to blow...

I removed the tank vent line and was able to blow through the vent hose from the tank side, so I believe it is clear.
Forum: Engines 11-15-2014, 08:58 PM
Replies: 12
Views: 8,422
Posted By dsbunton646
the only change since the last time it ran good...

the only change since the last time it ran good is the tach was working then and doesn't now. Other than that and the things listed (fuel pump, cap, rotor, plugs etc from trying to correct it). When...
Forum: Engines 11-15-2014, 07:44 PM
Replies: 12
Views: 8,422
Posted By dsbunton646
Well, I just got back from the Lake. I changed...

Well, I just got back from the Lake. I changed the cap, rotor and coil but still not running normally. It is fine until about 3/4 throttle and then it just bogs down as if it is running out of fuel....
Forum: Engines 11-13-2014, 11:59 AM
Replies: 12
Views: 8,422
Posted By dsbunton646
Thank you for the info. I am going to replace the...

Thank you for the info. I am going to replace the coil, distributor cap and rotor this week and see if it corrects it. I have removed the fuel lines, and pickup line in the tank. All lines are clear...
Forum: Engines 11-11-2014, 08:50 PM
Replies: 12
Views: 8,422
Posted By dsbunton646
1999 1900sr 5.0 won't run full throttle

I have had the carb rebuilt, new fuel pump, new filters, new spark plugs, new starter, and it still will not run correctly. It seems to bog at about 3/4 throttle and will not take a rapid...
Forum: Sport Boats 11-01-2014, 08:18 PM
Replies: 7
Views: 4,556
Posted By dsbunton646
Thanks. Its a 5.0.

Thanks. Its a 5.0.
Forum: Sport Boats 11-01-2014, 02:55 PM
Replies: 7
Views: 4,556
Posted By dsbunton646
I ordered a new starter so hopefully that's the...

I ordered a new starter so hopefully that's the problem. I really don't think it is hydrolocked as it was turning over fine for several minutes and it was just on the hose (not in the water). I know...
Forum: Sport Boats 10-30-2014, 08:46 PM
Replies: 7
Views: 4,556
Posted By dsbunton646
Would it even spin at all if that is the case? I...

Would it even spin at all if that is the case? I don't think its hydrolocked or anything as it was turning over fine for a while before it started this. If anything I may have overheated the starter.
Forum: Sport Boats 10-30-2014, 08:12 PM
Replies: 7
Views: 4,556
Posted By dsbunton646
starter problems

I recently had the carb rebuilt on my 1999 1900SR because the boat sat up for sometime with older fuel in it. I drained the old fuel etc changed filters, carb work etc. I went to start it (it would...
Forum: Maxum Owners General Discussions 02-28-2013, 12:39 AM
Replies: 6
Views: 1,615
Posted By dsbunton646
Thanks everyone. I looked all over and under and...

Thanks everyone. I looked all over and under and around and...well you get the idea. It is gone. I thought I'd find it laying under the motor but no dice. Thanks for links mcoffey.
Forum: Maxum Owners General Discussions 02-26-2013, 10:08 PM
Replies: 6
Views: 1,615
Posted By dsbunton646
Disregard, I finally found the part number and...

Disregard, I finally found the part number and located one on ebay.
Forum: Maxum Owners General Discussions 02-26-2013, 09:45 PM
Replies: 6
Views: 1,615
Posted By dsbunton646
Help!

Can anybody tellme where I can get a replacement cap for a drive oil reservoir on a 1999 Maxum 1900sr? I'm not sure how, or why, but mine is gone. I went to change the outdrive oil and I saw it is...
Forum: Maxum Owners General Discussions 04-14-2012, 12:11 AM
Replies: 6
Views: 2,062
Posted By dsbunton646
Although my boat is much smaller, I had a black...

Although my boat is much smaller, I had a black stripe painted on it to add some color to it as I was like you and tired of the plain jane look. Mine was all white (off white) to start with. The guy...
Forum: Maxum Owners General Discussions 04-08-2012, 12:36 AM
Replies: 7
Views: 2,227
Posted By dsbunton646
FYI. for anyone who may need a replacement as...

FYI. for anyone who may need a replacement as well. I have found one that is slightly longer than the original, but should work just the same at great lakes skipper. Good call on that one seapuppy....
Forum: Maxum Owners General Discussions 04-07-2012, 02:13 PM
Replies: 7
Views: 2,227
Posted By dsbunton646
Thanks everyone. I took it apart and tested the...

Thanks everyone. I took it apart and tested the power just before the base and all is good. The broken lense is junk but the socket appears good. Placed a new bulb and it won"t light up. I'm going to...
Forum: Maxum Owners General Discussions 04-06-2012, 12:06 AM
Replies: 7
Views: 2,227
Posted By dsbunton646
It is busted on the light end. I was thinking...

It is busted on the light end. I was thinking about buying one that is straight and rolling it with a pipe bender, not sure if that would work but afterall, its just thin metal of some kind. I will...
Forum: Maxum Owners General Discussions 04-05-2012, 02:21 AM
Replies: 7
Views: 2,227
Posted By dsbunton646
99 1900sr stern light

Anybody have a aftermarket replacement suggestion for the curved stern light on a 1900 sr? Mine is out of commission and I can't seem to find something to replace it with because it has about a 90...
Forum: Maxum Owners General Discussions 02-26-2012, 05:31 PM
Replies: 0
Views: 1,282
Posted By dsbunton646
installed smart tabs yesterday

I installed the smart tabs sx on my 1900sr yesterday. Hated to drill all those holse but it went fairly easy. I hope they work as described. Any body running them with a hydrofoil as well? I already...
Forum: Maxum Owners General Discussions 02-23-2012, 09:28 PM
Replies: 3
Views: 3,945
Posted By dsbunton646
I used a marine grade silicone similar to what...

I used a marine grade silicone similar to what you would use on through hull fittings to hold it on. I have had no issues with it thus far and it was put back on several years ago. If it needs to...
Forum: Maxum Owners General Discussions 02-12-2012, 05:46 PM
Replies: 13
Views: 2,458
Posted By dsbunton646
You are waiting until March? Oh wait, I live in...

You are waiting until March? Oh wait, I live in Florida. Joking of course, and yes I plan on being in the water in March too. Dropped mine off last week for a re-do of the upholstery and ordered...
Forum: Sport Boats 02-05-2012, 10:45 PM
Replies: 0
Views: 1,813
Posted By dsbunton646
1900sr Upholstery

So, last year I had my boat wet sanded, buffed, and some paint added on the hull. After replacing the decals and etc.. I used it last summer with some minor tears in the upholstery, mainly on the...
Forum: Engines 01-08-2012, 12:47 AM
Replies: 15
Views: 4,918
Posted By dsbunton646
It has to be a bearing or something. The power...

It has to be a bearing or something. The power steering could be the problem. It works goodthough. The water pump has to have a bearing inside as well for the pulley to spin. It's not the belt...
Forum: Engines 01-07-2012, 05:11 PM
Replies: 15
Views: 4,918
Posted By dsbunton646
At first I thought this was exactly what mine...

At first I thought this was exactly what mine is/was doing, but is coming from the engine and or pullys I think. It has a squeel that i can't find. I checked the belt, changed the tension pully and...
Forum: Maxum Owners General Discussions 10-19-2011, 02:04 AM
Replies: 6
Views: 2,831
Posted By dsbunton646
I checked some prices on wraps a while back from...

I checked some prices on wraps a while back from other places. They were pricey. The wetsand and buff would be better unless you just want something new. I ended up with a wet sand, buff and paint on...
Showing results 1 to 25 of 109

 
Forum Jump

All times are GMT. The time now is 12:45 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.