Reply
 
Thread Tools Search this Thread Display Modes
 
Old 05-19-2019, 04:56 AM   #1
Ensign
 
Join Date: May 2019
Posts: 1
Default Rub Rail on a 3200SCR

I am attempting to reseal my rub rail. I want to remove the rub rail in sections, clean it and reseal. I am finding every other screw going thru the stainless & rubber rail is a 3 inch machine screw and not the normal 2 inch standard stainless screw. Why is there machine screws? I started this on the rear port side. Thanks.
__________________

Mahalo is offline   Reply With Quote
Old 05-19-2019, 02:03 PM   #2
Lt. Commander
 
gmc60's Avatar
 
Join Date: Dec 2014
Location: Mass
Posts: 230
Red face Rub Rail

I did some of mine this spring ?
There are nuts on most of them, and the long stainless wood screws hold the boards in side boat on .(from outside yes) When the boards fall off you will see all the nuts and the top rail nuts also that leak more then rub rails from rubbing on docks and people grab it to pull you in. I did not go as far as to pulling black rubber out and taken off the base i sealed all the nuts and bolts and a few top bases 3M 4200 . All my leaks went away . So FAR

That is my short story

Bill
gmc60 is offline   Reply With Quote
Reply

Tags
rub rail

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Powered by vBadvanced CMPS v3.2.3

All times are GMT. The time now is 03:27 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2020, vBulletin Solutions, Inc.