4200 SCR lacking full power

[shrew]

So, if the props were the issue, I wonder why you were getting such different numbers on both sides?

[Marcs4200max]

Are you saying that the factory pitch was 26 and not 25? Where did you find this information? Thank you1

[shrew]

Originally Posted by Marcs4200max

Are you saying that the factory pitch was 26 and not 25? Where did you find this information? Thank you1

This is an old thread and I believe the OP is long out of boating. There are a couple of key prop measurements

<Prop_Diameter> x <Pitch> x <Hub_Inner_Diameter(ID)>

It sounds like the OP finally settled on a 4 blade prop 23 x 26 x 2