Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: ss3964spd
Forum: Engines 07-29-2016, 07:31 PM
Replies: 74
Views: 8,795
Posted By ss3964spd
I think at this point I would by-pass as much of...

I think at this point I would by-pass as much of the boat's fuel system as possible.

Set up a temporary 5 gal tank on the deck and run a fuel line from it directly to the input of the pump. Make...
Forum: Engines 07-06-2016, 05:59 PM
Replies: 74
Views: 8,795
Posted By ss3964spd
Some links in case you've not found them yet. ...

Some links in case you've not found them yet.

https://www.boatfix.com/merc/bullet/83/83_24.pdf
...
Forum: Engines 07-06-2016, 05:41 PM
Replies: 74
Views: 8,795
Posted By ss3964spd
I went back and re-read your 1st post. Motoring...

I went back and re-read your 1st post. Motoring along at 3K then just dead, no sputtering etc. Checked for fuel which was there. Ran it again and same symptom. But then in post 11 there are new...
Forum: Engines 07-06-2016, 02:46 PM
Replies: 74
Views: 8,795
Posted By ss3964spd
5.5 PSI output is still good, especially for a QJ...

5.5 PSI output is still good, especially for a QJ since they don't like high pressure, and even more so if it has a high flow needle and seat assembly. The real test is when the engine dies, and...
Forum: Engines 07-05-2016, 03:02 PM
Replies: 74
Views: 8,795
Posted By ss3964spd
That particular vacuum port in the photo is above...

That particular vacuum port in the photo is above the throttle blades and therefore won't likely have any vac at idle, or very little, but will when the throttle is open. Regardless, as Mike said,...
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT. The time now is 11:54 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.