Maxum Boat Owners Club - Forum

		Maxum Boat Owners Club - Forum > Search Forums
Search Results

Click Here to Login

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: racer2c

Forum: Maxum Owners General Discussions

09-24-2009, 05:12 PM

Replies: 14

Trim Tab Installation Question

Views: 4,180

Posted By racer2c

Re: Trim Tab Installation Question

LOL!! I'm laughing because I KNEW you were going to spot that and tell me to paint or seal it!! Too funny!! That was where Maxum had a clamp that secured the fuel hose to the bhd. They screwed it at...

Forum: Maxum Owners General Discussions

09-24-2009, 01:43 AM

Replies: 14

Trim Tab Installation Question

Views: 4,180

Posted By racer2c

Re: Trim Tab Installation Question

Here is the finished tab job. Very pleased with the placement. Bennett recommends as far outboard as possible but with at least 3" to the chine, which I was able to do. I wanted to follow the contour...

Forum: Maxum Owners General Discussions

09-23-2009, 08:45 PM

Replies: 14

Trim Tab Installation Question

Views: 4,180

Posted By racer2c

Re: Trim Tab Installation Question

I took some afterward that I'll post up soon. I was too heads down to take pics along the way.

A few tips...'dry run' all screws (without sealant). I used the the larger of all pre-drill sizes...

Forum: Maxum Owners General Discussions

09-23-2009, 07:17 PM

Replies: 14

Trim Tab Installation Question

Views: 4,180

Posted By racer2c

Re: Trim Tab Installation Question

Well, another extremely satisfied trim tab customer!!! We set out in consistent 2' seas, tabs fully retracted and experienced the ever annoying 'hull slap' that beats you up after just minutes. A...

Forum: Maxum Owners General Discussions

09-15-2009, 12:38 AM

Replies: 14

Trim Tab Installation Question

Views: 4,180

Posted By racer2c

Re: Trim Tab Installation Question

Thanks SP. I wired it up to direct power and ran the ground to the battery and presto...active trim tabs! Can't wait to get her in the water this weekend to try them out!~

Forum: Maxum Owners General Discussions

09-14-2009, 01:55 PM

Replies: 14

Trim Tab Installation Question

Views: 4,180

Posted By racer2c

Re: Trim Tab Installation Question

Yeah, it's the right place alright. The port side has about an 1" build up of glass, starboard side has maybe a 1/4" at best. I went ahead and used a 5"x5" piece of 3/4" pressure treated plywood as a...

Forum: Maxum Owners General Discussions

09-12-2009, 07:11 PM

Replies: 14

Trim Tab Installation Question

Views: 4,180

Posted By racer2c

Trim Tab Installation Question

So I'm deep into my trim tab install and I'm drilling the holes to attach the actuator to the transom. When I drilled my pilot holes I discovered that the transom area that I want to drill through is...

Showing results 1 to 7 of 7

All times are GMT. The time now is 03:53 PM.