Go Back   Maxum Boat Owners Club - Forum > Search Forums
Reload this Page Search Results
Click Here to Login
Register FAQ Community Calendar Today's Posts Log in

Showing results 1 to 11 of 11
Search took 0.00 seconds. Search: Posts Made By: RandR
Forum: Engines 08-29-2015, 03:38 PM
Replies: 19
Views: 3,911
Posted By RandR
Finally got it set...I think ........the marina...

Finally got it set...I think ........the marina pulled the boat to remove the outdrives. A shell of some sort has grown and attached to the inside of the water passage in the outlive. They removed...
Forum: Engines 08-10-2015, 09:35 PM
Replies: 19
Views: 3,911
Posted By RandR
Finally got back down to the boat, I talked to...

Finally got back down to the boat, I talked to the shop and they said that they did not change the hose when they did the bellows. I did some more investigating, pulled the elbows, everything was...
Forum: Engines 08-02-2015, 01:11 PM
Replies: 19
Views: 3,911
Posted By RandR
I don't know. I has the shop do that. I will...

I don't know. I has the shop do that. I will check with them. It is not noted on the invoice.
Forum: Engines 08-02-2015, 01:08 AM
Replies: 19
Views: 3,911
Posted By RandR
Changed both impellers this spring and the port...

Changed both impellers this spring and the port one again last weekend New manifolds and risers this spring. New thermostat last weekend. All new bellows and shift cables the past spring ...
Forum: Engines 08-01-2015, 07:59 PM
Replies: 19
Views: 3,911
Posted By RandR
So while at anchor I climbed into the eng...

So while at anchor I climbed into the eng compartment and pulled one Jose off the fuel cooler and it was clear Also checked the check valve. Water ran out fast but I could not blow back through. ...
Forum: Engines 08-01-2015, 05:50 PM
Replies: 19
Views: 3,911
Posted By RandR
Ok so I got to run the boat today. all was...

Ok so I got to run the boat today. all was pretty good on the dock. Here are the temps after 10 mins idle.
Starboard engine
Starboard side. [port side)
Top of riser 87(83)
Top manifold...
Forum: Engines 07-28-2015, 03:11 AM
Replies: 19
Views: 3,911
Posted By RandR
Please try this one ...

Please try this one

https://www.michiganmotorz.com/images/res/22-863786A-1_site_456_272.jpg

The meecruiser part number is 22-863786A
Forum: Engines 07-28-2015, 02:41 AM
Replies: 19
Views: 3,911
Posted By RandR
It is raw water cooled not a closed system. I...

It is raw water cooled not a closed system. I can grab a picture when I a on the boat. Here is a link to the part from the internet
...
Forum: Engines 07-28-2015, 01:16 AM
Replies: 19
Views: 3,911
Posted By RandR
I probably won't get the boat out until the...

I probably won't get the boat out until the weekend but as soon as I can I will get and post all those temps. There are two hoses that go into the bottom of the manifiold with some sort of check...
Forum: Engines 07-27-2015, 05:30 PM
Replies: 19
Views: 3,911
Posted By RandR
To clarify port engine port manifold 181 ...

To clarify port engine port manifold 181

Starboard engine port manifold 150

I don't recall what the starboard manifolds were but they were basically close to the port and didn't seem much...
Forum: Engines 07-26-2015, 11:01 PM
Replies: 19
Views: 3,911
Posted By RandR
Dual Engines - one hotter than the other

This has been driving me nuts and I have not been able to find the problem. I have a 2005 3300 I purchased last September, with 67 hours on each engine,(merc 5.0 MPI) last fall it ran fine and I did...
Showing results 1 to 11 of 11

 
Forum Jump

All times are GMT. The time now is 09:40 AM.

Contact Us - Maxum Owners Club - Archive - Community Rules - Terms of Service - Privacy - Accessibility - Top

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.