Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: pgp
Forum: Projects and Customisations 09-18-2014, 09:55 PM
Replies: 18
Views: 7,583
Posted By pgp
Sounds good. I will get to mine soon. I am...

Sounds good. I will get to mine soon. I am still trying to figure out how to get my fuel flow meters from the engine room to the dash.....
Forum: Projects and Customisations 09-17-2014, 06:51 PM
Replies: 18
Views: 7,583
Posted By pgp
I have sealed mine and will be cutting a new...

I have sealed mine and will be cutting a new floor soon. If the floor is sealed in then a hole is useless.......
Forum: Projects and Customisations 09-03-2014, 12:22 AM
Replies: 18
Views: 7,583
Posted By pgp
Dang that looks about as good as mine :)

Dang that looks about as good as mine :)
Forum: Projects and Customisations 09-02-2014, 07:00 PM
Replies: 18
Views: 7,583
Posted By pgp
I would normally agree with but, the old floor...

I would normally agree with but, the old floor was glassed in and there was no way for any water to get down into that part. Unless the table insert hole allowed water to go through? My table...
Forum: Projects and Customisations 09-02-2014, 06:16 PM
Replies: 18
Views: 7,583
Posted By pgp
Not done the repair yet. I am still trying to...

Not done the repair yet. I am still trying to decide if I should plug up the drain in that compartment before I repair it. The only water coming in is from the engine bay and there is no other...
Forum: Projects and Customisations 07-07-2014, 07:45 PM
Replies: 18
Views: 7,583
Posted By pgp
Roger, Thanks for the reply. I get water in...

Roger,

Thanks for the reply. I get water in my aft bilge but not sure where it is from. It is salt water. I wet/dry vac it out and go on a run and when I get back there is water. Not sure if...
Forum: Projects and Customisations 07-07-2014, 05:06 PM
Replies: 18
Views: 7,583
Posted By pgp
Mike, The PO used a 1/4 piece of ply to fit...

Mike,
The PO used a 1/4 piece of ply to fit over the hole. When I lifted the carpet it was more rotten than when he placed the ply there. No bounce just a sinking feeling as your foot went into...
Forum: Projects and Customisations 07-07-2014, 01:54 PM
Replies: 18
Views: 7,583
Posted By pgp
3000SCR replacing rotted floor in aft cabin

I have just purchased a 2000 3000SCR and have found that the floor in the aft cabin is rotted out. I am about to glass in a new piece of ply but i want to know if anyone else has had this problem? ...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT. The time now is 04:35 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.