Forum: Engines
06-04-2014, 01:59 PM
|
Replies: 32
Views: 7,325
6/2014 Update: A Brewer Shipyard mech finally...
6/2014 Update: A Brewer Shipyard mech finally "adjusted" the carb for a 2nd time, idles but the idle was set to 1,000 rpm in error based on what I've read which should be @ 650 like its twin. How...
|
Forum: Engines
10-30-2013, 08:46 PM
|
Replies: 32
Views: 7,325
|
Forum: Engines
10-30-2013, 05:16 PM
|
Replies: 32
Views: 7,325
Update from the yard: After way too long of a...
Update from the yard: After way too long of a wait from the marina they finally had their more experienced mechanic check the carb & found a "broken spring" on the butterfly/choke which seems to be...
|
Forum: Engines
10-02-2013, 10:36 PM
|
Replies: 32
Views: 7,325
|
Forum: Engines
10-01-2013, 03:03 PM
|
Replies: 32
Views: 7,325
Mike, The boat & twin engines are all year...
Mike, The boat & twin engines are all year 2000... (Mod 3000SCR)... Question on the jumper since I'm a hot wiring novice: I would cut the flat terminal ends off, strip the ends & just twist...
|
Forum: Engines
10-01-2013, 12:58 AM
|
Replies: 32
Views: 7,325
Mike, no, I don't think this year/models was...
Mike, no, I don't think this year/models was TKS...I believe it's standard 5.0L 2bbl carb..won't seem to idle cold or hot, therefore can't put into gear or even in neutral w/out it stalling. If I...
|
Forum: Engines
10-01-2013, 12:48 AM
|
Replies: 32
Views: 7,325
|
Forum: Engines
09-29-2013, 09:50 PM
|
Replies: 32
Views: 7,325
Thanks Pascavone.. Makes sense as its starving...
Thanks Pascavone.. Makes sense as its starving for fuel at low rpms.. I'll have to hand it back over to the yard if its an air leak/gasket.. I'll see if I can rule out the OP 1st & go from there..
|
Forum: Engines
09-29-2013, 09:46 PM
|
Replies: 32
Views: 7,325
|
Forum: Engines
09-29-2013, 03:22 PM
|
Replies: 32
Views: 7,325
|
Forum: Engines
09-29-2013, 03:16 PM
|
Replies: 32
Views: 7,325
[QUOTE=mmwjr;30225]Max you can pull te 2 wires...
[QUOTE=mmwjr;30225]Max you can pull te 2 wires off the OP switch and jumper them together. Make a short jumper of the same guage wire and put blade connectors on it same as on switch. If this allows...
|
Forum: Engines
09-29-2013, 03:34 AM
|
Replies: 32
Views: 7,325
|