Showing results 1 to 12 of 12
Search took 0.00 seconds.
Search: Posts Made By: mmwjr
Forum: Maxum Maintenance 04-25-2016, 04:14 PM
Replies: 28
Views: 4,104
Posted By mmwjr
Do you have a picture of it from the outside?...

Do you have a picture of it from the outside? that type of installation is typically a transducer however I have seen speedo impeller installed this way.

Either way it is connected to an...
Forum: Maxum Maintenance 04-22-2016, 10:53 PM
Replies: 28
Views: 4,104
Posted By mmwjr
Got a picture or the model number of the unit at...

Got a picture or the model number of the unit at the helm?
Forum: Maxum Maintenance 04-22-2016, 10:48 PM
Replies: 28
Views: 4,104
Posted By mmwjr
Yep starboard drive pitot is connected to helm...

Yep starboard drive pitot is connected to helm speedo.

Do you have the aftermarket unit that uses the thru hull paddle wheel?
Forum: Maxum Maintenance 04-22-2016, 01:49 AM
Replies: 28
Views: 4,104
Posted By mmwjr
Try heating the ring with a heat gun but not too...

Try heating the ring with a heat gun but not too hot. Then use channel locks to turn it.
Forum: Maxum Maintenance 04-22-2016, 01:14 AM
Replies: 28
Views: 4,104
Posted By mmwjr
May I ask why, disturbing it may cause it to...

May I ask why, disturbing it may cause it to leak. So unless you plan to remove it completely and fill the hole I would let it be.
Forum: Maxum Maintenance 04-21-2016, 10:06 PM
Replies: 28
Views: 4,104
Posted By mmwjr
Oh it's a tru hull, not seen these typically....

Oh it's a tru hull, not seen these typically. Mine is mounted on the entire of the transom.

Is you plan to remove it and fill the hole?
Forum: Maxum Maintenance 04-20-2016, 10:02 PM
Replies: 28
Views: 4,104
Posted By mmwjr
Mine is screwed into the transom.

Mine is screwed into the transom.
Forum: Maxum Maintenance 04-20-2016, 09:58 PM
Replies: 28
Views: 4,104
Posted By mmwjr
What is it plugged into? Ones I have pull out...

What is it plugged into? Ones I have pull out once the locking collar is undone
Forum: Maxum Maintenance 04-20-2016, 09:49 PM
Replies: 28
Views: 4,104
Posted By mmwjr
Does it look damaged? Remove any marine growth...

Does it look damaged? Remove any marine growth and hit with PB blaster
Forum: Maxum Maintenance 04-20-2016, 04:08 PM
Replies: 28
Views: 4,104
Posted By mmwjr
Water should never get to the helm as the air in...

Water should never get to the helm as the air in the tube will block it. Now if the tube were to break in the helm area then yes water may leak here.
Forum: Maxum Maintenance 04-20-2016, 04:06 PM
Replies: 28
Views: 4,104
Posted By mmwjr
That paddle wheel is for an aftermarket GPS combo...

That paddle wheel is for an aftermarket GPS combo unit. I have one as well and it also has a built in water temp sensor.
Forum: Maxum Maintenance 04-20-2016, 11:36 AM
Replies: 28
Views: 4,104
Posted By mmwjr
The pitot is built into the leading edge of the...

The pitot is built into the leading edge of the outdrive about inline with the water intake. The tube then connects to the top of the lower unit just below where the exhaust bellows attaches.
Showing results 1 to 12 of 12

 
Forum Jump

All times are GMT. The time now is 01:33 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.