Forum: Engines
05-26-2013, 06:49 PM
|
Replies: 34
Views: 9,636
All done. Spark plugs set at .045. Time for a...
All done. Spark plugs set at .045. Time for a test run maybe today or tomorrow
https://img.tapatalk.com/d/13/05/27/3aha6eqe.jpghttps://img.tapatalk.com/d/13/05/27/uze5ypu2.jpg
Sent from my VS920...
|
Forum: Engines
05-24-2013, 07:53 PM
|
Replies: 34
Views: 9,636
Just think how much fun its going to be...
Just think how much fun its going to be installing all our new stuff.
Not going to be a good weekendfor boating... winds 20 to 25. Gust to 30. With three foot waves.....
Todd
Sent from my...
|
Forum: Engines
05-24-2013, 05:55 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
05-21-2013, 06:37 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
05-21-2013, 01:59 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
05-16-2013, 12:51 PM
|
Replies: 34
Views: 9,636
It appears I have a bad Coil,
I think this...
It appears I have a bad Coil,
I think this is what happened to my coil!
Your plug gap is based on the output of your coil. The hotter the coil, the wider the gap. A 30,000 volt coil would gap...
|
Forum: Engines
04-30-2013, 04:32 PM
|
Replies: 34
Views: 9,636
Dan, I love project boats...keeps me busy. Its...
Dan, I love project boats...keeps me busy. Its electronic ignition. I have the wiring diagram. Going to dig into it this weekend. Since I just replaced the eng, I am hoping its a loose wire/bad...
|
Forum: Engines
04-30-2013, 11:33 AM
|
Replies: 34
Views: 9,636
I replace the fuel pump and after running for a...
I replace the fuel pump and after running for a day and a half everything seemed to be fine. Cruising along at 3000 rpm the engine sputtered backfired and wouldn't start. Troubleshooting revealed I...
|
Forum: Engines
04-25-2013, 03:05 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
04-19-2013, 04:53 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
04-19-2013, 03:33 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
04-19-2013, 12:55 PM
|
Replies: 34
Views: 9,636
It has a spacer plate. I couldn't make out the...
It has a spacer plate. I couldn't make out the intake casting number(old eyes), but it is defiantly a spread boar intake. I took out the tank pickup tube and sucked out some gas (from the bottom of...
|
Forum: Engines
04-18-2013, 10:47 PM
|
Replies: 34
Views: 9,636
Dan, you are right ,,,,, its a Weber, 3310-805484...
Dan, you are right ,,,,, its a Weber, 3310-805484 (9661)... after typing my fingers to nubs, I looked in the Mercruiser Manual and there it was..LOL
Todd
|
Forum: Engines
04-16-2013, 04:59 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
04-16-2013, 12:51 AM
|
Replies: 34
Views: 9,636
|
Forum: Engines
04-15-2013, 04:39 PM
|
Replies: 34
Views: 9,636
It’s a quadrajet, and as far as I know it has...
It’s a quadrajet, and as far as I know it has never been apart. This Carb doesn't have a Filter in the inlet. I replaced the inline filter and the Water/fuel filter, cleaned out the Fuel pickup...
|
Forum: Engines
04-15-2013, 12:30 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
04-11-2013, 03:38 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
04-11-2013, 02:04 PM
|
Replies: 34
Views: 9,636
|
Forum: Engines
04-10-2013, 09:38 PM
|
Replies: 34
Views: 9,636
Fuel line clogged
The fuel pickup tube inside the fuel tank has a small screen in it. And this is what I found
Todd
Sent from my VS920 4G using Tapatalk 2
|