Go Back   Maxum Boat Owners Club - Forum > Search Forums
Reload this Page Search Results
Click Here to Login
Register FAQ Community Calendar Today's Posts Log in

Showing results 1 to 12 of 12
Search took 0.00 seconds. Search: Posts Made By: canada randy
Forum: Sport Cruisers 06-30-2010, 02:35 AM
Replies: 19
Views: 5,290
Posted By canada randy
Leak down test showed 8 % loss or less on all...

Leak down test showed 8 % loss or less on all except #6 cyl. Which was 20%. Appears exhaust valve. Not sealing proper and possibly sticking. I may (should) pull that head off when i do intake...
Forum: Sport Cruisers 06-25-2010, 02:18 AM
Replies: 19
Views: 5,290
Posted By canada randy
I'm going to have to run engine to warm up at...

I'm going to have to run engine to warm up at shop. I have muffs i used on the alpha. Will they work on the bravo 2 . Or is the raw water intake somewhere else? Thanks
Randal


added;
Should...
Forum: Sport Cruisers 06-24-2010, 05:22 PM
Replies: 19
Views: 5,290
Posted By canada randy
Just purchased leak down tester. Will either pull...

Just purchased leak down tester. Will either pull out boat and bring to shop or take portable compressor and genset to dock. Dock where its at right now has no electricity. Merc says compression...
Forum: Sport Cruisers 06-24-2010, 05:10 AM
Replies: 19
Views: 5,290
Posted By canada randy
Another quick health check you can do is to warm...

Another quick health check you can do is to warm up the engine, let it idle, remove the oil fill cap, wipe the opening of oil, and place a piece of paper over the opening. If the paper (don't use...
Forum: Sport Cruisers 06-24-2010, 02:49 AM
Replies: 19
Views: 5,290
Posted By canada randy
Ya thanks. I haven't even bought the boat yet. So...

Ya thanks. I haven't even bought the boat yet. So the fun hasn't even begun. I'm figuring what it needs to calculate puchase price. And what i need to do to get it up to par. I have some experience...
Forum: Sport Cruisers 06-24-2010, 01:02 AM
Replies: 19
Views: 5,290
Posted By canada randy
I tried with paper, then paper towel. Didn't...

I tried with paper, then paper towel. Didn't suck.Had to hold over opening. Slight pressure pushing out. Almost neutral. Used soap on intake.Bubbles both sides of intake R&L at gasket at exhaust...
Forum: Sport Cruisers 06-23-2010, 03:37 AM
Replies: 19
Views: 5,290
Posted By canada randy
Its center manifold right side by carb , maybe...

Its center manifold right side by carb , maybe inch back. If i pull boat out is there grease nipple on u-joint or gimble bearing behind 1995 Bravo 2 drive (should i pull off drive)?. A saw grease...
Forum: Sport Cruisers 06-22-2010, 06:52 PM
Replies: 19
Views: 5,290
Posted By canada randy
I have to look closer. I showed my auto mechanic...

I have to look closer. I showed my auto mechanic on a car approx where coming from. He thinks possible cross over area. Is that exhaust cross over? Looked at cap and rotor earlier. Looks old and...
Forum: Sport Cruisers 06-22-2010, 04:24 PM
Replies: 19
Views: 5,290
Posted By canada randy
Blades held open .Only warmed up slightly for...

Blades held open .Only warmed up slightly for couple minutes. Wasn't sure about working on hot engine.My auto mechanic can't figure air leak either. I'll do intake gasket myself. Have some experience...
Forum: Sport Cruisers 06-22-2010, 04:32 AM
Replies: 19
Views: 5,290
Posted By canada randy
Has anyone had 7.4 with 17 3/4"x21P aluminum...

Has anyone had 7.4 with 17 3/4"x21P aluminum quicksilver w/bravo 2? If so what was your max rpm and speed trimmed with light boat? From what i've read this was standard on bravo 2 for 1995 2700scr.
Forum: Sport Cruisers 06-22-2010, 04:22 AM
Replies: 19
Views: 5,290
Posted By canada randy
Thanks will check points etc tomorrow.Go from...

Thanks will check points etc tomorrow.Go from there.Should i switch to electronic ignition?Point system may have to do for now. Btw Clean water on intake from owner cleaning boat.Noticed tiny air...
Forum: Sport Cruisers 06-21-2010, 08:36 AM
Replies: 19
Views: 5,290
Posted By canada randy
Question 1995 2700 scr7.4L low rpm

Making a deal on 1995 2700scr 7.4(454) bravo 2. When owner took me out first trip looked like 4000rpm(maxed) at 33mph.I test drove it by myself today and only got 3800rpm at 30mph(tried various trim...
Showing results 1 to 12 of 12

 
Forum Jump

All times are GMT. The time now is 05:15 PM.

Contact Us - Maxum Owners Club - Archive - Community Rules - Terms of Service - Privacy - Accessibility - Top

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.