Forum: Engines
06-27-2022, 02:17 PM
|
Replies: 11
Views: 712
|
Forum: Engines
06-11-2022, 08:16 PM
|
Replies: 11
Views: 712
|
Forum: Engines
06-11-2022, 06:08 PM
|
Replies: 11
Views: 712
|
Forum: Engines
06-11-2022, 05:31 PM
|
Replies: 11
Views: 712
9.7V at ignition.
I can’t find anything I...
9.7V at ignition.
I can’t find anything I can reach on the starter that isn’t battery voltage or no reading, but it’s very difficult to see / reach with the battery in place, so might be missing...
|
Forum: Engines
06-11-2022, 05:21 PM
|
Replies: 11
Views: 712
|
Forum: Engines
06-11-2022, 12:45 PM
|
Replies: 11
Views: 712
Thank you!
Sorry for the dumb questions, but...
Thank you!
Sorry for the dumb questions, but does the key need to be turned when checking the voltage at those points? Is the fuse at the starter the one between the positive battery cable and alt...
|
Forum: Projects and Customisations
06-11-2022, 05:45 AM
|
Replies: 3
Views: 2,113
|
Forum: Engines
06-11-2022, 05:43 AM
|
Replies: 11
Views: 712
No ignition
Hi,
I have a newish 5.7L mercruiser MPI
A few weeks ago, I started the boat up to go out, then it choked and died. Started again, ran for thirty seconds then died. Third time, nothing at all (...
|
Forum: Maxum Owners General Discussions
09-04-2020, 06:02 PM
|
Replies: 5
Views: 810
|
Forum: Maxum Owners General Discussions
09-03-2020, 09:36 PM
|
Replies: 5
Views: 810
|
Forum: Electronics
09-03-2020, 09:34 PM
|
Replies: 4
Views: 531
Ah, of course. Circuit breaker. The cable from...
Ah, of course. Circuit breaker. The cable from the breaker to the pump is heavier than the pump leads by at least one size, so they should be fine. Unfortunately, the old leads were about six inches...
|
Forum: Electronics
09-03-2020, 09:28 PM
|
Replies: 2
Views: 480
|
Forum: Sport Cruisers
09-03-2020, 03:32 PM
|
Replies: 4
Views: 818
|
Forum: Electronics
09-03-2020, 03:28 PM
|
Replies: 4
Views: 531
FW pump fuse
My FW pump failed so I switched to a bigger one because bigger is better, right?!
Now it runs for a few minutes before popping the fuse. I’m assuming I need a bigger fuse for the higher power...
|
Forum: Sport Cruisers
09-03-2020, 03:01 PM
|
Replies: 2
Views: 706
Is the gouge just in the gelcoat or has it...
Is the gouge just in the gelcoat or has it damaged the fiberglass?
They were probably describing the colour mix to match the gel coat colour. Manufacturer info wouldn’t help that much on an older...
|
Forum: Electronics
09-03-2020, 02:17 PM
|
Replies: 2
Views: 480
Wiper issue
I was cruising home in a light rain recently and started the wiper. Rain stopped, I shut off the wiper, wiper kept on going. The switch is led lit and was kind of flickering on/off. As soon as we got...
|
Forum: Maxum Owners General Discussions
09-03-2020, 02:12 PM
|
Replies: 5
Views: 810
Trim tab replacement
Hi all,
The starboard trim tab on my 2500SE ripped off (just the tab, hydraulic cylinder still there though I’m unsure of the condition until I can get the boat out of the water). Does anyone...
|
Forum: Maxum Owners General Discussions
07-06-2020, 04:50 AM
|
Replies: 7
Views: 1,121
|
Forum: Engines
07-05-2020, 04:42 PM
|
Replies: 4
Views: 604
|
Forum: Engines
08-18-2019, 03:08 AM
|
Replies: 1
Views: 784
Intermittent no start
Hi all,
A couple of times now, my engine has not started - doesn’t turn over, just makes a click, then nothing when key is turned. I’ve read some past threads and seen that this is likely either a...
|
Forum: Engines
08-08-2019, 02:35 AM
|
Replies: 11
Views: 1,158
|
Forum: Engines
08-08-2019, 02:29 AM
|
Replies: 11
Views: 1,158
Hi folks,
So I replaced the thermostat,...
Hi folks,
So I replaced the thermostat, changed the coolant, backflushed the raw water system, and inspected the heat exchanger. Nothing notable came out of the system and the old thermostat...
|
Forum: Sport Cruisers
08-02-2019, 11:41 PM
|
Replies: 9
Views: 1,143
|
Forum: Engines
08-01-2019, 09:59 PM
|
Replies: 18
Views: 1,780
On my boat, I had the serial numbers for the...
On my boat, I had the serial numbers for the drive and the boat, but the number for the engine had rubbed off (I know it's also stamped on the block, but way at the back somewhere...). The local...
|
Forum: Engines
07-31-2019, 02:31 AM
|
Replies: 13
Views: 1,109
|