Showing results 1 to 12 of 12
Search took 0.00 seconds.
Search: Posts Made By: Derek in AZ
Forum: Electronics 05-23-2022, 07:56 PM
Replies: 2
Views: 1,032
Posted By Derek in AZ
Advice on a not so great battery setup

Howdy,

I have a 98 Maxum 3200 SCR. Twin 7.4L V8 w/ bravo III. Before I purchased it in 2011 someone really worked over the electrical system. In a nutshell, the only way that anything works, is...
Forum: Maxum Maintenance 08-23-2012, 10:54 PM
Replies: 9
Views: 3,858
Posted By Derek in AZ
Sorry if that came off as harsh. I really meant...

Sorry if that came off as harsh. I really meant no offense. I value all of your ideas highly and use this forum a heck of a lot. I just get frustrated...
Forum: Maxum Maintenance 08-23-2012, 09:33 PM
Replies: 9
Views: 3,858
Posted By Derek in AZ
Thanks for the info fellas. However, I have...

Thanks for the info fellas.
However, I have tested the shore power with an oscilloscope and am absolutely positive that it is good clean power. The pump seems to pump a sufficient amount of...
Forum: Electronics 08-10-2012, 05:54 PM
Replies: 12
Views: 3,808
Posted By Derek in AZ
Just wanted to update everyone on what I finally...

Just wanted to update everyone on what I finally found out about this issue...

After contacting a friend of mine who is an electrical engineer and conducting tests with a bunch of fancy equipment...
Forum: Maxum Maintenance 08-10-2012, 05:44 PM
Replies: 9
Views: 3,858
Posted By Derek in AZ
Cleaning AC Heat Exchanger

Hello again from AZ,
Last month I replaced the compressor on my 98 3200SCR because it continually tripped the HP switch and shut the unit down. It worked well for about a month. Now... its...
Forum: Electronics 07-11-2012, 12:30 AM
Replies: 12
Views: 3,808
Posted By Derek in AZ
So I went out today and did some work on it. ...

So I went out today and did some work on it. When i arrived I notice that the shore power is a solid 120V when not loaded. The Generator unloaded was bouncing between 108-112V. So, i adjusted the...
Forum: Electronics 07-10-2012, 03:32 AM
Replies: 12
Views: 3,808
Posted By Derek in AZ
Pascavone. Is the float switch a function of the...

Pascavone. Is the float switch a function of the carb? Meaning that it regulates RPM's and therefor the capacity of the generator?

As for doing a load test... i have shut everything off at the...
Forum: Electronics 07-09-2012, 04:44 PM
Replies: 12
Views: 3,808
Posted By Derek in AZ
Air Conditioner Capacitor

Hey Gents,
Heres the issue. My air conditioner on my 1998 maxim 3200 SCR works fine when connected to shore power. However, when i attempt to run it off of my generator (4.5 BCG A) it "Browns...
Forum: Sport Yachts 05-10-2012, 05:15 AM
Replies: 4
Views: 1,587
Posted By Derek in AZ
Ill give it a shot tomorrow. Thanks for the...

Ill give it a shot tomorrow. Thanks for the info. BTW the voltage at the switches was only 4 volts... does that seem odd?
Forum: Sport Yachts 05-09-2012, 07:13 PM
Replies: 4
Views: 1,587
Posted By Derek in AZ
I Did this project yesterday. No issues...

I Did this project yesterday. No issues replacing this in the water. However, my port outdrive is stuck in the full up position. From reading it looks like there is a position sensor somewhere...
Forum: Sport Yachts 05-07-2012, 10:05 PM
Replies: 4
Views: 1,587
Posted By Derek in AZ
Replacing the Props

Hello Again from Arizona,
I have a 3200SCR with Bravo 2 outdrives. I hit some rocks on monday and bent, the props on the starboard motor. I have extras but was curious if i needed to pull the...
Forum: Maxum Maintenance 03-20-2012, 08:10 PM
Replies: 1
Views: 1,882
Posted By Derek in AZ
Bow Thruster chokes out starboard engine

Howdy from Arizona,
I have a Maxum 3200 SCR with bow thrusters. The bow thrusters work fine when i am at the dock connected to shore power, but if I actuate it when i am off shore power with...
Showing results 1 to 12 of 12

 
Forum Jump

All times are GMT. The time now is 03:19 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.