Forum: Sport Yachts
05-21-2012, 02:34 AM
|
Replies: 11
Views: 5,046
|
Forum: Sport Yachts
05-21-2012, 02:11 AM
|
Replies: 11
Views: 5,046
Dock side water hook up
I am thinking of installing some type of dock side water hookup to my 99 3200scr instead of using the fresh water tank. Has anyone installed a kit or designed there own system to work? Just looking...
|
Forum: Engines
03-11-2012, 01:04 AM
|
Replies: 1
Views: 1,987
HELP!! Westerbeke Carburetor
So Friday I come home from work early " Good start to a weekend " and decide to finish up repairs on the westerbeke 4.5 before installing it back in the boat at the end of the month. I tried sliding...
|
Forum: Maxum Owners General Discussions
02-26-2012, 03:39 PM
|
Replies: 3
Views: 1,739
Boat Striping
Hi everyone, I am looking at restriping my boat. Does anyone have recomendations on who to order from and what type " Reflective or Non reflective striping "
|
Forum: Engines
01-21-2012, 07:57 PM
|
Replies: 0
Views: 1,571
Bravo II Water Supply Hose
Hi guys, any advice on how hard it is to replace the water supply hose for the Bravo II outdrive? It goes from the gimbal housing to the bell housing. I know I need a special tool for the 2 plastic...
|
Forum: Engines
01-17-2012, 12:34 AM
|
Replies: 5
Views: 1,710
Best recommendation for anodes
Hi everyone, just looking for a recommendation. Could anyone tell me what they think would be the best anode kit for my Bravo II in sea water? Thanks guys
|
Forum: Electronics
01-08-2012, 02:04 AM
|
Replies: 7
Views: 3,404
Make sure none of your pressure switches are...
Make sure none of your pressure switches are shorting to ground. The oil pressure switch is the one that is notorius to short to ground. Check either terminal to ground, you should not have any...
|
Forum: Engines
11-21-2011, 12:28 AM
|
Replies: 12
Views: 3,133
|
Forum: Engines
11-21-2011, 12:25 AM
|
Replies: 3
Views: 1,831
|
Forum: Engines
11-20-2011, 12:47 PM
|
Replies: 3
Views: 2,258
|
Forum: Sport Yachts
11-20-2011, 02:05 AM
|
Replies: 4
Views: 1,904
Hi guys I know this is a late post, but soon...
Hi guys I know this is a late post, but soon after I posted I found that the inline fuse at the battery disconnect panel had 12v going to it but was not feeding 12v to the trim tab switch. The...
|
Forum: Engines
11-17-2011, 02:01 PM
|
Replies: 12
Views: 3,133
I removed both hoses at the raw water pump and...
I removed both hoses at the raw water pump and had my buddy start the engine for a couple of seconds. The suction from the pump was strong and pulling the palm of my hand. The suction hose for the...
|
Forum: Engines
11-16-2011, 01:21 AM
|
Replies: 12
Views: 3,133
|
Forum: Engines
11-15-2011, 01:08 AM
|
Replies: 12
Views: 3,133
99 maxum 3200 Engine will not flush
Hi everyone, I pulled boat from water this past weekend. I flushed the starboard engine and it flushed fine. When I went to flush the port side it would not pull water from the water intake/strainer....
|
Forum: Sport Yachts
11-14-2011, 01:48 AM
|
Replies: 2
Views: 1,398
Thanks for the quick reply. Finally someone who...
Thanks for the quick reply. Finally someone who knows what they are talking about. Well I put a new impeller kit in today and the old one was definately breaking apart. I lubricated the impeller with...
|
Forum: Sport Yachts
11-12-2011, 11:31 PM
|
Replies: 2
Views: 1,398
99 scr3200 overheat
Good evening everyone,
Well I pulled my boat out this weekend and started to winterize the engines. I hooked up the cups to the starboard engine and like always it flushed fine. I went and hooked...
|
Forum: Sport Yachts
09-30-2011, 12:05 AM
|
Replies: 4
Views: 1,904
|