outdrive trim

[jeffronin3]

My left outdrive only lifts up about one third of the way and then stops. The motor is new and it also stops, would this just be the stop sensor???

[mmwjr]

Is this happening when using the trim up switch? If so the trim limit switch needs adjustment, it's located on the side of the gimbal ring. Loosen the two screws and rotate it until proper trim up is achieved. Note it should only trim all the way up by using the trailer button.

[jeffronin3]

Ok thank you I will check this this weekend. Thank you again. And by the way is this in the engine compartment?

[Phillbo]

No, on the transom just below the outdrive.

[jeffronin3]

Can this be done while the boat is in the water?

[Gugi47]

Originally Posted by jeffronin3

Can this be done while the boat is in the water?

Yes if you know what you doing.......

[jeffronin3]

Ok not so sure what I'm doing so probably going to have to wait until winter since I'm in Michigan lol. Thanks again!!!

[mmwjr]

Originally Posted by jeffronin3

Ok not so sure what I'm doing so probably going to have to wait until winter since I'm in Michigan lol. Thanks again!!!

Oh so next week.

It’s one of those round pucks on the side of the transom assembly.

[jeffronin3]

Yeah I've been looking at manuals and videos on how and what and where. Thanks again.
And only expecting up to two inches of rain this weekend not snow yet lol.