Reply
 
Thread Tools Search this Thread Display Modes
 
Old 08-13-2008, 01:53 AM   #1
Lt. Commander
 
Join Date: Feb 2008
Location: Notts UK
Posts: 186
Default Standard Timing settings on a 1996 4.3 Vortec?

Does anyone know the standard timing settings for the 96 4.3 merc? I've read quite a few conflicting reports but I've seen this a couple of times:

ground out the purple/white wire before start and then set 10 degrees before TDC with a timing light

Does anyone agree/disagree I've got the service manual but can't find anything in it other than just setting it to near TDC to get it running after rebuild

Thanks again

EDIT: having just read the sticky at the top of this page. so the mark on the front pulley is 10 degrees BTDC not TDC is that right? and according to that I need to make it 7 degrees?. I've made a vernier scale and stuck it on but assumed that the mark was TDC?????
__________________
Gaz
Gazjen is offline   Reply With Quote
Reply

« Rebuild Time | temp »
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Ski tow replacement jman Maxum Maintenance 3 11-14-2009 03:11 PM
Hydrualic tab motor irishladdie Maxum Owners General Discussions 2 10-05-2009 02:27 PM
TV in 2400 SCR jlanza14 Electronics 12 09-23-2009 12:25 PM
Water in fuel. Removal???? rgreenwell8962 Maxum Maintenance 5 12-16-2008 12:22 AM
depth sounder Finn Electronics 1 07-17-2006 08:23 PM

Powered by vBadvanced CMPS v3.2.3

All times are GMT. The time now is 08:43 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2017, vBulletin Solutions, Inc.