Reply
 
Thread Tools Search this Thread Display Modes
 
Old 10-16-2017, 05:10 AM   #1
Ensign
 
Join Date: Oct 2017
Location: Hampton Roads area of VA
Posts: 6
Default New to boat owner 93 2700 SCR big block

I'm a new owner of a used 93 2700 SCR with 358 hrs of run time in salt water. Boat has been sitting on a trailer for two years when I bought it. I would like some advice on what I should do with the gas that is in the tank. I was thinking on pumping it out and putting new back in. I'm planning on giving the engine a thorough tune up. i.e new spark plugs, check plug wires, exhaust riser inspection, and engine cylinder compression check. along with checking all rubber penetrating hull to lower drive unit.

Will
__________________

sea cruiser is offline   Reply With Quote
Old 10-16-2017, 11:23 AM   #2
Admiral
 
mmwjr's Avatar
 
Join Date: Feb 2012
Location: Essex, Maryland
Posts: 10,175
Default

Welcome aboard

Do you know if it's E10 gas? I would remove the fuel filter and dump the contents into a glass jar to look for water and other containments. If you see any solids just pumping the tank dry may not be enough and the tank may need to be flushed to remove gunk.

It will most likely need new bellows and I would replace the gimbal bearing and low shift cable. Also change the gear lube in the drive and engine oil.
__________________

__________________
1997 Silverton 362, 7.4 Crusaders
1997 2400 SCR, 5.7 Vortec / Bravo 2

Mike
mmwjr is offline   Reply With Quote
Old 10-16-2017, 12:42 PM   #3
Moderator

 
shrew's Avatar
 
Join Date: Apr 2008
Posts: 5,588
Default

Welcome aboard sea cruiser!!

Does the previous owner have information on service, such as the last time the manifolds and risers were replaced? I agree with most Mike's list, plus a few more:

Oil & Filter Change
Fuel Filter
Belts
Plugs
Gimbal Bearing
lower shift cable
Drive Lube change
Bellows

Check to make sure that seacocks are moving properly.
clear and inspect seastrainers
Check all hoses for cracking
consider a head pump rebuild kit
check all bilge pumps
Inspect all nylon through hulls (Of they're chalky, they need to be replaced).
shrew is offline   Reply With Quote
Old 10-16-2017, 11:45 PM   #4
Ensign
 
Join Date: Oct 2017
Location: Hampton Roads area of VA
Posts: 6
Default

Thank you both for your prompt responses. I do not have any answers for the question you have. the owner was not present at the time due to traveling and the person that was storing his boat in his yard had some info for. The gas tank red E when the boat key was turn on so that can mean there is no gas or gauge is not working, i need to investigate this. I'm hoping the gas was not E10 type.
sea cruiser is offline   Reply With Quote
Old 10-16-2017, 11:54 PM   #5
Ensign
 
Join Date: Oct 2017
Location: Hampton Roads area of VA
Posts: 6
Default

Everything on list posted is in progress to be complete. I have a few question to ask. Where is the best place to get good value parts for the power plant? I was going to inspect the manifolds and risers. I'm thinking they are original parts when bought in 2006 with trailer. I'm sure they will have to be replaced also.

What is the cooler for on the fwd end of the engine. It looked like it had antifreeze in it.

regards
Will
sea cruiser is offline   Reply With Quote
Old 10-17-2017, 12:26 AM   #6
Admiral
 
mmwjr's Avatar
 
Join Date: Feb 2012
Location: Essex, Maryland
Posts: 10,175
Default

I prefer to use OEM parts and would search the net or local shops for prices. I have used several on line places, Doug Russell, marine power specialist, eBasic,... and have not any issues.

Sounds like the engine is equipped with closed cooling, that cylinder is a heat exchanger and acts like a cars radiator but instead of using air to carry away the heat it uses raw water. There are two types a full and half system, the full cools the engine and exhaust manifolds while the half only cools the engine. In both cases the elbows are raw water cooled.
__________________
1997 Silverton 362, 7.4 Crusaders
1997 2400 SCR, 5.7 Vortec / Bravo 2

Mike
mmwjr is offline   Reply With Quote
Old 10-17-2017, 01:00 AM   #7
Ensign
 
Join Date: Oct 2017
Location: Hampton Roads area of VA
Posts: 6
Default

Thank you for your information.

Can the manifold and riser inspection be preformed using a borescope or just remove the risers to do the inspection.

how is the gas tank flushed out?
sea cruiser is offline   Reply With Quote
Old 10-17-2017, 02:30 AM   #8
Admiral
 
mmwjr's Avatar
 
Join Date: Feb 2012
Location: Essex, Maryland
Posts: 10,175
Default

Just pull the risers to inspect.

Flushing the tank is something I would hire a licensed company to perform due to the explosive nature of the job.
__________________
1997 Silverton 362, 7.4 Crusaders
1997 2400 SCR, 5.7 Vortec / Bravo 2

Mike
mmwjr is offline   Reply With Quote
Old 10-17-2017, 10:46 AM   #9
Captain
 
Join Date: Sep 2015
Location: Chesapeake, VA
Posts: 526
Default

My rule of thumb is if the part is in the water or has anything to do with water getting into the boat or engine, I use OEM parts. Otherwise, I’ll use aftermarket engine parts, like cap, rotor, belts, etc. I buy almost everything off eBay. Try to build your list and order as much as makes sense from the same seller and request a shipping price to combine everything. And then Walmart actually has good prices on the fuel and oil filters..!
speedysprocket is offline   Reply With Quote
Old 10-17-2017, 08:28 PM   #10
Ensign
 
Join Date: Oct 2017
Location: Hampton Roads area of VA
Posts: 6
Default

Thank you neighbor for your information. I also live in Chesapeake.

Which ebay marine store do you use and how do you get part numbers for items you are buying for the power plant.
sea cruiser is offline   Reply With Quote
Old 10-18-2017, 04:36 AM   #11
Lt. Commander
 
MoonRiver's Avatar
 
Join Date: Oct 2017
Location: Spokane, WA
Posts: 228
Default Welcome Sea Cruiser

I'm also new to the site and find it very helpful. I don't envy your project, sea water can be evil on a boat especially one that has been out of service for so long.
I would definitely have that fuel system pumped out and flushed, plus a carburetor rebuild/ tune-up. The guys gave you an awesome list, I would add inspection/ replacing seawater pump & impeller.

Good luck out there in the Tidewater.

20yrs USN at LtCrk
MoonRiver is offline   Reply With Quote
Old 10-18-2017, 10:43 AM   #12
Captain
 
Join Date: Sep 2015
Location: Chesapeake, VA
Posts: 526
Default

Quote:
Originally Posted by sea cruiser View Post
Thank you neighbor for your information. I also live in Chesapeake.

Which ebay marine store do you use and how do you get part numbers for items you are buying for the power plant.


I go to mercruiserparts.com to find the part number and then paste that in eBay with sort by lowest price first. Then just figure out who has the best deal with shipping and such. And be careful, they can be tricky with selling aftermarket stuff in a post that can make you think it’s OEM.
speedysprocket is offline   Reply With Quote
Old 10-18-2017, 10:45 AM   #13
Captain
 
Join Date: Sep 2015
Location: Chesapeake, VA
Posts: 526
Default

Quote:
Originally Posted by MoonRiver View Post
I'm also new to the site and find it very helpful. I don't envy your project, sea water can be evil on a boat especially one that has been out of service for so long.

I would definitely have that fuel system pumped out and flushed, plus a carburetor rebuild/ tune-up. The guys gave you an awesome list, I would add inspection/ replacing seawater pump & impeller.



Good luck out there in the Tidewater.



20yrs USN at LtCrk


How do you like Little Creek now? I’ve been at Naval Station Norfolk the past two years. Was on the list for Little Creek, but didn’t like the idea of charging for water and electricity. I like flushing my engines and running the A/C too much...!
speedysprocket is offline   Reply With Quote
Old 10-19-2017, 02:50 AM   #14
Lt. Commander
 
MoonRiver's Avatar
 
Join Date: Oct 2017
Location: Spokane, WA
Posts: 228
Default

I loved Lt Crk as a duty station (SBU20). I never kept my personal boat there though.
MoonRiver is offline   Reply With Quote
Old 10-19-2017, 10:00 PM   #15
Captain
 
Join Date: Sep 2015
Location: Chesapeake, VA
Posts: 526
Default

Quote:
Originally Posted by MoonRiver View Post
I loved Lt Crk as a duty station (SBU20). I never kept my personal boat there though.


Oh ok. I was there when the PCs were still here. I’ll probably be back again. It is a cool base.
__________________

speedysprocket is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Powered by vBadvanced CMPS v3.2.3

All times are GMT. The time now is 01:04 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.