Tilt works, gauge does not!!!! HELP~!!!!!

[bmazz007]

Gauge seamed to be off at first now, it just does not move at all it just stays pinned to the top. the engine tilts fine.. Any clue???? :shock:

[seapuppy]

Bmazz.....what kind of engine drive combo do you have....???...can't offer any advice if we don't know what you have?.... :D arr

[bmazz007]

sorry :oops: I have a Alpha 1 305 -220 hp

[seapuppy]

oh...in that case a piece of cake.....down at the pivot point of the drive on each side is a round shaped puck ..that is the sensor for the drive angle which changes the gauge........check that puck down at the drive....sometimes the 2 screws back out.....and the puck will move and not register the change.....or it may have gotten some water intrusion and rusted the innards shut......
hope that helps.....mine did the same thing..they replaced the puck and they replaced the puck....let us know what you found out....

[bmazz007]

thank you will do!!! It was working the other day, so maybe its just the screws!!! :lol: